Network Security

Hi,We hv a PIX 515E- firewall setup in active/failover mode.Pls refer attached diagram.We hv to use the proxy server which is placed in DMZ as gateway for Inside users browsing.In other words all the internal users will be pointing to the DMZ proxy s...

I have Security Monitor 2.1.0 (Build 123) in a CW VMS 2.3. It collect events from some IOS IPS. The IOS IPS have the correct time. The events generated in the device has the correct time (I can see it with "show log" command). In the device, with "sh...

Our company use a product called Scansafe for web scanning. Every now and then we are sent a report from scansafe along the lines of:"The ScanSafe service discovered a possible virus or malicious code in a Web page or download accessed from within yo...

The 'idsmdc.log' & 'idsmdc.db' file under %NMSROOT%\MDC\Sybase\IDS folder has grown to 10GB & 6 GB respectively. I'm using VMS2.2 on Win2K Machine. What are these files, and how do I prune these files? Is there a perl script available to prune these ...

Hi! I'm wondering if there is the possibility of excluding an IP address from the RESET, even if the rule is matched. Thanks in advanceFrancesco

I am trying to connect to a On-line Game through PIX. But the connection is never successful. After I bypass the PIX, and connect to the Game Server. The connection is OK, and I can play the game. The PIX OS is 7.0.2. And I have uploaded two Sniffer ...

I have a classic EZVPN setup with a VPN3020 as the server and about 20 or so 831 clients. My problem is that you can't issue the qos pre-classify command under an EZVPN profile. In this case how would I prioritize traffic witin the EZVPN tunnel?

i know pix 6.3 support vlan,support 802.1q,i wonder if pix support routing between vlan?

Hello.I have Pix 506e firewall (ver. 6.3)iside ip - 0.0.1.1outside ip - 0.0.0.1So, I have proxy server with ip - 0.0.1.12And I want to configure my Pix to redirect all www traffic from my internal network (0.0.1.0) to proxy (0.0.1.12) port 8080.Can...

Dear All,im searching to download this 6.3(3) software . but i couldnt find it. can anybody from cisco pls give me the linkThanks in advance .RegardsNataraj

I am having translation issues, have tried upgrading to 7.0, then went back to 6.3, all because of NAT.I have the following setup: switch connects to Eth1 on PIX, PIX Eth0 goes out to border router. We have two networks, that need to go out to the ...

Can anyone advise on a recommended level of logging for a PIX firewall?I tried informational and debugging but in only a couple of hours I have a 700MB log file on my syslog server!We need to be able to investigate incidents if and when they arise re...

Hi, We have been using CiscoWorks 2.2 with SP3 for managing & monitoring security Agents, Firewalls & Sensors remotely. but for the past few days we have encountering problems in it and the subcomponents like IDS MC,CSA agents etc are'nt opening. t...