Network Security

Hi all, I try to do multiple context in transparent mode. My idee is to make a second IP for admin purpose that is not routed within the Internet and only accessible from my inside network.interface Ethernet0.1 vlan 1!interface Ethernet0.2 shutdown n...

CSA 4.5 has new groups/policies, like "Desktops - All Types" with policies attached like "Operating System - Base Protection". Does anyone know if these are intended to replace the 4.0x groups such as "Default Desktops" and "Common Security Module".....

I have a pix 515. it has 1 outside interface and 1 dmz interfaceThe dmz interface on the pix is 192.1268.1.1The dmz is a 192.168.1.x networkThe pix is doing NATThe pix is NATing an outside address to a server in the dmz that is 192.168.1.3There are a...

Wen I want to connect to the media server with from outside the CPU of my PIX up 80% and the traffic in interface DMZ goes to 29000 Kbpsb (the microsft media server is in the dmz interface). the connection fron inside work fine.With the version 6.34 ...

Hello,I am trying to debug and see why one host on our inside network, gets access to a specifc web site correctly. Then within that web site, the user tries to print a report that displays in a sperate window, the page comes blank and it says page c...

1. How do I "break" the SHOW RUN output before reaching the end of the script? On a router any key does this but not so on my PIX 506E!!!2. Why does the TAB key not complete the command? My book says it should!!!Much appreciated.

Hello all,I got 2 links from different ISPs with different public IPs ranges. Both links connected to router 2821XM via Serial interfaces. Both router ethernet interfaces assigned IP public IP addresses (ISP1 and IPS2 respectively). Default route on ...

dear ,one of my client wants a PIX 525 with three Gigabit interface.I can not configure it.My client wants PIX-525-UR-GE-BUN. But it has no extra gigabit interface.Pls tell me what to do.

My PIX failover is happening frequently.When i checked in Syslog I found the following message.After this failover some of my IPsec tunnels are establishing .Pls help %PIX-4-405001: Received ARP request collision from 10.0.0.1/0011.bb85.62be on inter...

We are installing a PIX to isolate a network. Initially, we want to allow and monitor all traffic to pass either way. This will allow us to build thee rule set to be applied later.What is the easiest way to open the PIX up and act only as a router wh...

Looks like IDSM2 not geting all traffic from switch. Security acl configuration looks ok. Can we use tcpdump -i sy0_1 or some thing else to see all traffic send to IDSM2 by switch ?

hi everyone, I know that the new PIX version 7.0 is not supported on the Hardware Platform 520. Why?? Any ideas? Can I use it without any support???? Rene

We've set up the access lists on the inside and outside interfaces to have the first entry be "allow any IP traffic to/from the Class C " that these websites are on and log that traffic. We do see the log messages on the Inside traffic going outbound...

Most of our WAN uses EIGRP for routing. Up to now most of the connectivity to our major sites has been primarily via PTP circuits with LAN to LAN IPsec VPN tunnels serving as backup - either via CVPN 3000 to CVPN 3000 or CVPN 3000 to a Pix of some so...