Network Security

i have made this config from the cisco website. will this config work for me, so that my exchange smtp traffic comes and goes thru this pix.nameif ethernet0 outside security0nameif ethernet1 inside security100nameif ethernet2 dmz security50enable pas...

Can anyone tell me what the performance statistics are for a PIX 515? I found the following for the newer PIX 515E but cannot find anything for the original 515 device. Also, are these numbers completely idealistic scenerios or do they hold up in rea...

hich protocol to linkage they use? e.g: 515E with IS-ONE ids? thanks everybody.mac.z

Good Day;I am having trouble with configuring multiple outside public IP@ to a single inside private IP that uses various ports.Has anyone a solution on how to do this on the PIX 515 v.6.2?I have no problem to NAT multiple inside private IP@ to a sin...

why online games did no be loded after immplementing the pix

Here is the situation. One PIX515E, 3 catalyst 2950-48 EI. PIXs outside interface is connected directly to internet(ISP).I post similar question at vlan, trunking etc. conversation, but i think this is firewalling issue.In a FAQ i read that PIX must ...

I have configured a hub/spoke PIX (515/506) Point to point network. I can see the tunnels come up. I can ping from each pix console the peer. I can access (telnet) external devices from an internal device (split-tunnel works). However, I am seeing 2 ...

Ok folks this one got me baffled.I have a client that that uses Citrix client to connect through the internet to a Citrix Server. ALL works well except the timeout..I have my pix set to timeout ideal tcp connections after 60mins.. On the server side ...

PixOS 6.3 starts supporting 802.1q, is this correct? If not, which version starts supporting it? And even 6.3 supports 802.1q, Pix 506e doesn't support it. Is that the case? Thanks.

We notice that our PIX logs (handled by a Linux-basedsyslog) do not contain all of the accessed URL's recorded by our Apache HTTP server. Are there any known problems in this area?Bill

I have installed a 501 pix at a remote office and am using the vpn client 4.01 I can connect just fine from my dial up connection at home and can access what ever files and computers I need to However from my other office where I am in a private netw...

I have a customer who has a Chcekpoint Firewall and they are looking to migtrate it to PIX 506. However, I just found out that they have 2 Internet connections coming in from the 2 different providers, also they have 2 different blocks of addresses o...

I have configured cable Failover using as well as statefull failover using a crossover cable. The failover works fine but the state does not. When I transfering a big FTP file and pull an ethernet cable from the active unit it failsover to the standb...

Pix 515E running 6.3(3) code. xlate timeout is set to default = 3 hours. there hasn't been any activity for days. current "show conn" shows no connections. however, the xlate table is full of old entries. should the xlate entries be flushed after 3 h...