Network Security

How many seperate VPN tunnels can you specify through crypto map statements?

HiI am configuring PIX firewall for remote VPN clients. For Key authentication we are using Microsoft CA server.I am configuring the firewall but it seems that it is not communicating to the CA server. When i enroll for the certificate , i m getting ...

My solaris vpn client 4.0 gives me the message below every time I try to run it:"The application was unable to communicate with the VPN sub-system."The windows client works fine in the same network. The installation process seems to be succesfull (ex...

I have a proxy server on my internal 10.x network, I want this machine to use an ADSL service as it default gateway. The ADSL service is on a Vigor ADSL router. However, I want any traffic between the proxy server and the ADSL service to go through t...

Is it possible to upgrade my 525 FO to an unrestricted license? I would like to use it with my primary PIX in an active-active configuration.thanks in advance,Jericho

I need to select hub-and-spoke VPN technology. There are ~60 spokes (17xx routers) and central site (2x 3725 for redundancy, one ISP).There is a plan to monitor routers and other equipment with HP OpenView NNM 6.41 (without ET). Also for routers main...

I am a little confused as to what this feature is designed to provide. I've been experimenting with this based on the examples in the CCO documentation.Can anyone offer me any insight into the design of this feature?My initial understanding was that ...

Hi,Does somebody have experience in setting up an ipsec tunnel between a ftp win2k client behind a checkpoint firewall which will connect to a ftp server behind a pix firewall? if possible can you send some configs for this? that'll be very much appr...

Hi,I am trying to set up a PIX 501, and would like to have separate IPs for the inside interfaces. Is there a way to assign an IP to each port? or is this something that requires 2 inside interfaces? What I am trying to do is to segment the network a...

Does this model 506 support OSPF with 6.3 ios? Thanks in advance.

Does anyone have a configuration to have the ability to telnet from the outside network to a Cisco PIX? We're using a 501 within our network that is protecting a group of servers, but our administrative network and aaa server would be located (consid...

I have a client that needs to use HTTPS for an internal service. I also need to have access from the outside to do configuration changes on the PIX via the PDM.I have enabled the internal network to use the PDM and my external IP addresses. However, ...

Hello,I've got a PIX 501 and every other day or so, the network comes to a grinding halt and it has been identified that the PIX is the culprit. The utilisation is always very low and in fact little traffic really passes through the PIX. Tried a diff...

NAT services have been reduced to only 2 vlans.The computers on the remaining vlans use ISA_Server for access to the internet.The syslog server has tremendous amounts of the following messages:305005Error Message IREFO BJ:24101%PIX-3-305005: No trans...