Network Security

Hello, does anyone know any method to retrive directly from a PIX his logs in a crypted (i.e. secure) way without a VPN? Thank you Paolo

I am looking to redesign the way the routers work on my network. My plan is to have a Pix that will police the network internally and will forward any outbound traffic to a cisco 3620 with firewall and VPN which users will use to access the internet ...

Hi,I have two pix,version and interface as follow.when I implement failover(rs232 and crossover cable connected),there is some problem.when the secondary pix power up,the two pix state will changed frequency.however,the pix connect to css11151(also c...

Do you know if there is a tool that will convert conduits to ACL's on the PIX 520. I found the information on how to do it using CiscoWorks, but this customer is not running CiscoWorks.

I have a PIX 515 running version 6.1(1) with 32 MB of RAM and a P200.I have it configured for PAT and NAT. My configuration follows below. My problem is that one of the IPs I have will not work at all. If I make a static entry for x.x.x.245 and map i...

I am not able to import my PIX 525 configuration into my VMS Management Center for PIX Firewalls. It doesn't seem to support the 'filter url' PIX commands. Is this something that just isn't supported at this time or am I missing something?

hi:How can i Configure PIX to Allow Remote Access to SharedFolders on an Windows 2000 or Active Directory.i have only found the solution for windows NT .thanks!!

Hi everybody,Just to know if there's some basic tasks necessary to secure a PIX (like we can find on the document "securing routers") or all is OK by default ?Is the option : access via telnet + tacacs enough secure or is there some potential "securi...

In pix 515 when from outside(not internet other WAN site) anybody tries to access inside network it can't . But if i ping from inside network to outside network host it pings and after this outside network access the inside network resources easily u...

Hi all!We make operate a two PIXs in failover configuration (an unrestricted license and a failover license). We have decided to order a spare PIX unit for case one of them goes wrong. My question is: what kind of license do we have to order the PIX ...

Here's the output of sh ver on my PIX515E:0: ethernet0: address is 0009.e8bf.6972, irq 101: ethernet1: address is 0009.e8bf.6973, irq 112: ethernet2: address is 0002.b303.b721, irq 11Licensed Features:Failover: DisabledVPN-DES: EnabledVPN-3DES: Disab...

I have a big doubt about what really involves the "Used Memory OID" 1.3.6.1.4.1.9.9.48.1.1.1.5.1 (Cisco Memory Pool Free), because when i try to monitor and graph this OID and the "Free Memory OID (1.3.6.1.4.1.9.9.48.1.1.1.6.1)" in the MRTG, the sum ...

HiI want to setup netmeeting from the outside to the inside interface on a PIX 515E 6.1.(4). Our PIX is setup without any NAT. Which ports do i need to open?

We have a situation here that is confusing us and I am asking for assistance with this one. We have a pix firewall configured with a single outside and two inside interfaces. Behind one of the inside interfaces, we run a Ms Isa server and have severa...