Network Security

HI,Can we specify 2 Outside gateways on the PIX .Although its is not possible but in version 6.3 I have to put the command :route outside x.x.x.x x.x.x.x z.z.z.z& route outside y.y.y.y y.y.y.y a.a.a.a And it was showing both the Command in PIX Runnin...

Hay guys iam very new to the Pix firewall...i had to work on a pix firewall 515 with ios 5.2 the other day all i had to do was run the internet adsl modem on the outside and just a hub on the inside with afew pc'sbut i couldnt get it to workthe probl...

I´m trying to upgrade a pix classic.These are my doubts:1. Do I have to do the following "For PIX releases earlier than 4.1.x, upgrades must be performed in major releases. For example, you must upgrade from PIX 4.0.x to 4.1.x., then from 4.1.x to 4....

Hi All,What is the minimum bandwidth configurable for end-user by BBSM? Is it possible to allocate 8Kb or 16Kb?Thanks in advance,Richard

I cannot RADMIN in through the router/VPN device. I need access from the outside for any remote tech support. This was working for a while. Do the port numbers on the VPN router need to be opened? -

This is more a routing and security issue I think.Have pix 515e with 3 interfaces. Original network setup in the following scenario. Inside interface has 10.11.60.0 network Outside interface 67.64.x.x dmz interface has 192.168.1.0 network. setup addi...

Does any one know if there will be any support for https filtering with a pix/n2h2 solution. I know support for websense has been added but not for n2h2. N2H2 states on their website that their product does support HTTPS filtering but the pix does no...

Hi folks-upgraded my 525 to OS 6.3 and PDM v3.I've set up a site-to-site vpn with IKE, but my opposite side tells me that they can see my 'internal' address range. Slightly worrying- I can't see why. Shouldn't it be natting out everything on my exter...

Hi!After upgrading a PIX 501 from ver 6.2.2 to the latest software (6.3.3) my vpntunnel to a VPN 3005 won´t go up again. (I use "Base Group" in the Concentrator.)The following shows in the VPN 3005 log. But I don´tunderstand what to do.If I "downgrad...

I am trying to initiate VPN tunnels to a number of remote sites using the Cisco VPN client. The site I am connecting from is behind a PIX 501 firewall.I cannot connect to a number of these sites with the PIX 501 in place; if the PIX is removed, or if...

Hi folks,Does anybody know of any tool to manage VPN routers appart from VMS? The problem is I need to manage IPSec connections on several 7500 routers and VMS has no support for 7500 routers. I don´t think there is one but I am checking just in case...

my client got a pix 525-ur with two interface card . now i got a icmp ping problem with this pix device when i made some test. the follow is the test environment PC1 ---- (inside) PIX (outside) --- PC210.47.240.22 10.47.240.254 10.47.253.253 10.47.25...

We are using a Failover Cable for failover. We are also using stateful failover between the PIX 515 firewalls using a FastEthernet interface. I really need some info about the following:1. If the failover cable fails (or was removed), while the 2 fir...