Network Security

I want to force users on a public hotspot to accept a user agreement (web page) before they get access to the internet. I would prefer to have this user agreement come up and respond to any HTTP request their web browser asks for until they accept it...

HiRecently I noticed that my setup with two pix 520 in failover is not functioning. (s/w 5.1(4). cable based failover).Looking at "show ver" on both pix i found that one of the pix (primary at present) has VPN DES-3DES Enabled where as in Standby uni...

Hi, I have a PIX 506 with a 3DES tunnel to a PIX 501. I would like VoIP traffic to tunnel without encryption or at least less encryption. I was thinking about using tunnel interfaces(i've created 'int tunnel 0' on 2600/1700 routers in the past) becau...

It seems there have been alot of tunnel issues with Cisco and Nortel, But I have not been able to find a resolution. My issue is, during rekey of the vpn tunnel between a Cisco PIX and Nortel Contivity, I incur timeouts and usually require a clearing...

Does anyone knows what following syslog message means?no route to IP1 from IP2where IP1 is PIX PAT address and IP2 is remote server addressAnyone had this log?

I need to run a "show mod" report for our 4006's in CW2K to determine which ones are experiencing Astro Errors. Does anyone know if this is possible ?

Any ways of getting QOS on the PIX 515E?

Hi.Having just read a doc regarding how failover is implemented on PIX 515Es - I noticed something that I'm hoping somebody out there will have a good answer for:"It is recommended that you connect the Primary and Secondary PIXes with a dedicated swi...

Dear sir,I have a pix and set some ACLs on it. the ACL would logging the match times as:"show access-listaccess-list outside permit tcp any host 211.156.53.18 eq www (hitcnt=1995331) access-list outside permit icmp any host 211.156.53.18 (hitcnt=4099...

I have a PIX 515 which has VPN clients connecting from multiple locations. When two people VPN (using client software) in the pix from the same location, then connect to the terminal server, the VPN tunnel stays up, but, the TS sessions are dropped.I...

can someone tell me how i can monitor dhcp addresses inside the pix 501/506 series. i would like to see how many addresses are in use and who is using them. thanks

Could anyone on this forum let me know whether CSPM will work Redhat linux operating system or we have any other software to manage sensors for linux ? very urgent higly appreciated your response thanks in advance thanks

I’m trying to limit the static routes which get redistributed into OSPF with an IP access list on a PiX running 6.3(1). When I try to apply the access list to a route map with “match ip address 110” I get the following error from the PiX:Extended acc...

I have 1 Pix 506 with VPN to Pix 506 and with 1 VPN 1751. When I start the tunnel from the 1751 it is OK, but I can start the tunnel from the PIX !!!Thanks.

This is my situation.PIX 501 connected to Alcatel ADSL router. The Alcatel router is connected to the internet (fix ip add) and performing PAT. In between the alcatel and pix outside interface I´m using add 192.168.100.x.In my pix I have the followin...