Network Security

I have recently moved my PIX to a cyber center, change the internal ip and subnet and external ip and subnet, change the ACL and static entry to reflect the address change but the ACL still doesn't work can anyone help on this?I have outside addresse...

I currently use the 3002 HW Client at several ROBO/SOHO locations in Network Extension mode. This works great. Recently I have the need to establish the same type of connection, but I need to provide a dynamic IP NAT pool for the clients behind the 3...

I am able to establish a VPN connection through a 3000 Concentrator that is owned and supported by our local ISP. When I run MS Systems Management Server 2.0 SP2 from the VPN client I am able to connect to the SMS site server but when I try to expand...

As I wrote in the forum transparent tunneling is working with the concentrator and with the brand new IOS 12.2(13T) NAT-T gives also for the routers a possibility to make IPSec via a NAT/PAT device. But, what is with the PIX? I couldn't find in the C...

I have a PIX501 configured with static command to provide access from outside to an internal server. This works flawlessly, nevertheless as soon as I applied the static command my internal network can not browse the Internet all of a sudden! Any idea...

I keep getting this error on boot up of my pix 501 and don't know what it means."Error: can not add name attributeType help or '?' for a list of available commands." Any ideas?

Hi all!I have configured a PIX with two outside interfacesnameif ethernet0 outside security0nameif ethernet2 outside2 security0On one interface the network 172.16.1.0/24, on the other the network 172.16.2.0/24 can be reached. The PIX can communicate ...

Hi all!If I use two firewalls in redundant configuration and the PIX terminates IPSec, do the active and standby PIX replicate IPSec and IKE session information (spi number, actual DES key, packet sequence, ...) or in case of the active PIX fails doe...

Can I use VPN Manager for VPN management of Cisco 2621 ?It is any limitation of using VPN Manager?Thanks very much

Does the newest IOS allow IPSEC to pass-thru?? Here is my situation. I have have a 2514 with many internal addresses overloaded to one public address and Cisco VPN client doesn't work many to one translation. What is my best bet??

hithe problem: CiscoWorks 2000 could not be able to discover the 2620XM and 1751!!! and it show the map with a "?" with device type (ciscoProducts.468 for 2620XM and ciscoProducts.326 for 1751)PLZ any one have iea about this ... Thankx

Have a PIX 501 that is moving, via nat, traffic from the inside to the outside interface with no issues (ISP on the outside interface). The problem that I have run into is this, residing within the lan on the inside interface is another network via a...