Network Security

From my understanding, a PIX will not process and/or accept routing protocol updates from RIP but it it has IPSec tunnel connected networks available then it is capable of advertising via RIP the networks that are available thru it.Is this correct? I...

Hi!I can´t figure out what is the problem when i get this:No translation group found for tcp src dmz2:10.5.215.1/1272 dst dmz3:10.6.5.19/143Inspite of these lines in my config:nat (dmz2) 0 10.5.215.0 255.255.255.0 0 0static (dmz2,dmz3) 10.5.215.0 10....

Looking for any ideas:I have installed vpn access on the pix. When the client logsin from from home using their cable connection they can access everythingon the LAN. However, their Internet access does not work through therelocal connection.To fix t...

I am trying to install a pix 515 behind my cisco 827h adsl router. I use the adsl line to provide internet access to my workstations. I cannot access the internet after installing with the following configurations. I set the workstations gateway to 1...

If I configure two websense servers, will the PIX load balance them or will it use one as a back up? I cannot really find any documentation on how the PIX handles multiple websense servers.Kevin

Hi.I am very frustrated. I have been searching for this client on the Cisco web site for 3 days now. Can anyone tell me where I can download it?Thanks in advance.

Hi all,Can anyone tell me how to configure pix so that I can get NTLM authentication working. I have a web server in my DMZ which needs to talk to my inside network to allow the authentication to function. What ports do I need to open up?ThanksSantos...

Hi there,I ran into specific problem with new PIX 515 that we purchased to replace old Netscreen. The problem is pretty known: message on PIX "PIX is not accepting new connections". The solution is also known: go and fix your syslog server (if it's c...

Does anyone know if it is possible to copy a configuration file (not a PDM or Image file) from a TFTP server to a PIX?

The L3 switch carries vlans whose routing is performed through virtual interfaces. What wanted to be achieved is to apply qos weighted round robin queueing to the egress (uplink) interface of this L3 switch with the purpose of prioritising certain ty...

I have a two interface PIX in a lab. I am trying to simulate this for a customer.Th PIX will be used between two Private networks in the same campus for some political reason. On a PIX outside Interface the network is 172.16.10.0/24, and inside netwo...

Hi using PIX 6.2(2)I am able to translate from the outside to the inside using static (outside,inside)but should i be able to NAT usingglobal (inside) 1 192.168.0.129-192.168.0.253global (inside) 1 192.168.0.254nat (outside) 1 0.0.0.0 0.0.0.0 0 0i ge...

I get this error in my firewall logs: Feb 26 15:32:49 firewall %PIX-6-106015: Deny TCP (no connection) from 161.58.238.151/110 to a.b.c.d/3782 flags RST ACK on interface outsideIs this telling me that my connection timeout or is someone trying to hac...

Hello,our company has just introduced VPN dialup connections via the Cisco VPN client 3.6 and a Cisco 3000 series concentrator. My question is:Is it possible to encrypt the user password and save it to the .pcf-file, so as not to have any clear text ...

I am new to firewall , i got PIX525 for our company, i configured with PIX with three interfaces , everything works fine , i can connect to dmz from outside ,i can connect outside and DMZ from inside .How i can check that my configuration is right an...