Network Security

I'm trying to find a way to get a Cisco router or switch to send an SNMP trap when a frame is received greate than a certain size. I'd also like the trap to include the source and destination addresses and the protocol (don't want much huh?). I'm o...

My PC with Win NT 4.0 workstaion OS (SP6) installed with VPN clinet ver 3.5.1 facing some connection problem. During or after the PC connected to ISP with VPN clinet s/w, the PC occasionally restart by itself. Anybody have any idea on this problem ?...

Hi ,Here is my scenario:Remote PC---->ISDN 800 Router------->ISDN 2600 Router----->24 port Switch----> From Switch one port goes to PIX inside interface and OUtside interface goes to---->Internet Router.All my local clients can access internet with N...

Is it possible to let client to access local LAN and Internet?I did it with VPN Client 3.6.2A and it works just fine. But pptp not.So is it possible at all?

Hello,I'm planning on setting up client vpns for my coworkers. We have a novell 4.11 fileserver too, runnin ipx. Can I tunnel the IPX protocol to the clients as well?TIA,-- Jeroen

Hi there...anyone have or know where to get a MIB for the VPN 3000 box?I want to see if I, through SNMP, can trigger the box to tftp or ftp the config to a remote server for backup purposes. Has anyone tried anything like that with this product?Thank...

Hi, I'm in the need of upgrading a Pix 515 ver. 4.4 to the last OS version (6.2). Does anyone know of any issue about an upgrade from such an old version?Also I would like to save the activation key before proceeding but I can't find any way to displ...

Need to know size for the following flash memory:" Flash i28F640J5 "*used to see PIX flash memory reference in cisco.com, but unable to find it now(?).Thanks

vpn 3030 snmp error in cisco works 2000I want to monitor vpn3030 through vpn monitor,so do some config on vpn3030:1)Configuration | System | Management Protocols | SNMP enabled port 1612)Configuration | System | Management Protocols | SNMP Communitie...

cspm 3.0f server and pix520 are connected to a 3524 switch,After finish topology in cspm 3.0f,I found cspm3.0f can't appove the command to pix520,it complains : Rule unenforceable, no managed device found from CNPC8 to pixfirewallRule unenforceable, ...

Bandwidth Control through Policies on VPN3000 Queue: VPN DevicesQuestion Description: ---Fri Jun 07 07:50:59 PDT 2002---We have a number of ADSL Home users and Dial-up(PSTN) users terminating VPN tunnels on a VPN3060. As the number of users increase ...

Can a PIX 501 be an endpoint for an GRE Tunnel?When using with a Cisco 3600?

We have a WAN with a PIX and (2) 2620 routers in the following config...Internet<--PIX<----LAN1----Cisco2620<----HDLC Serial-----Cisco2620<---LAN2Currently hosts on both LAN1 and LAN2 are able to talk to one another only after adding entries to their...

I am trying to use a VPN tunnel to allow a workstation to periodically appear on a real world IP address on the external side of a 3005. I have set up appropriate group and address pools. Once connected the client cannot see the internet nor can ...