Network Security

Hello,When I am trying to add a Collector baesd on a UDP port, targetted to an IP LDAP Device, on the port 30389, I have the error message :IPM Error Dialog :Target must be a regular IP Device (not a router) when the target port is less than 1025.But...

I have a PIX 525 running 6.1.1 OSI have an ACL from outside to inside. Atfter an undefined time the pix stops forwarding traffic from outside to inside. The only way I have found to fix the problem is to remove and then re-apply the ACL and it willl ...

Does anyone know about interfacing a Cisco PIX and a CheckPoint Firewall on the same segment? In my company we have this situation and the log (in both devices) presents a lot of alerts about a land attack (that is to say packet with the same source ...

I have problems to get nfs ( special mountd ) through a PIX. The nfs host is in a test segment which is separated from our intranet with a PIX. Our default policy is to disallow anything, except of some protocolls (ports) to defined hosts (this is tr...

I understand the serial # will have an "A" for std and "EN" for Enterprise. Is there any way I can find this electronically? I also understand that I can load EN software to a std (A) switch but only the std features will be operational . So can I tr...

Hello,What does this output mean when I do show int on a pix 525: input queue (curr/max blocks): hardware (128/128) software (0/4) output queue (curr/max blocks): hardware (0/11) software (0/10)I understand that this refers to the currently used and ...

Hi,Doing a "conduit" to "access-list" conversion in the PIX, I noticed there were no equivalent to the "embryonic" parameter in the static command :static (DMZ/Internet) <ip address> <ip address> 0 500where 500 is the number of half-sessions (embryon...

I attempted to load IOS 6.2.2 on a PIX 520 firewall. I was incredibly unsuccessful and violated my change window immensely. Essentially the software was not doing any PAT or NAT translation. I cleared all my configs and wrote only the NAT/PAT configu...

Is ACS31 support user changeable password from VPN(VPN3000) client, or any document that I can read.RegardsShinyaw

Customer will deply CW2K RWAN and LMS (only selected products) on up to 4 SunFire 280R servers. They have around 820 routers and 1,800 switches. I'm wondering is a single servers might support CD One, RME and Campus Manager with RME Availability Moni...

Hi,Is it possible to log the output produced by "debug" commands to syslog? I do succeed in sending debug level information (%PIX-6-*) to the syslog, but what I would really need is low level output. (e.g. for a "debug fixup tcp" I want the "tcpseq: ...

Hi everyone, I have a quick question, i have two pix 501, both has a 10 user license, i'm going to create a LAN to LAN tunnel between them. Just want to make sure, how the pix going to count how many user conneting, by session? source IP or by MAC ad...

I have any server ( DNS, SMTP, www) in inside interface with private IP address.With static command i traslate public address in private address:static (inside,outside) 200.21.225.243 mail netmask 255.255.255.255 0 0 static (inside,outside) 200.21.22...