Network Security

We have some internal links which have recently become part of an external organisation. I would like to connect them onto one of the interfaces on our PIX515, just one problem we have IPX/SPX running on the link. What normally happens in this situat...

I have a 3600 router on one side of a Pix firewall, tring to send the syslog file to a sensor on the other side of the firewall. The sensor is on a network that is unroutable and needs a spoof address on the Pix.I can see the router logging access li...

Can anyone point me to a list of what vpn clients are supported with what versions of software.More specifically, does anyone know at what version the 3000 vpn client is supported?

I'd like to be able to get syslog data from the remote firewall in our environment. We have pix-to-pix vpns connecting them.It doesn't want to work for us and I'm curious if someone's figured a way for it to work.Thanks in advance.....

Dear All,Pix software version 5.3.2Pix 520, Four interfacesINTERNET--Connected to Global Internet only, ISP 193.108.210.1 OUTSIDE--Connected to second ISP 193.173.249.65, from outside to our Webser on the DMZ INSIDE--Users 10.8.0.0, Intranet Server 1...

Below is an error message generated while i'mtrying to ssh into pix (6.1(1)):als@stinky:/usr/src~> ssh -c des pixwarning: Remote server talks SSH-1.5 protocol.Host key not found from database.Key fingerprint:xovib-duziz-cokaz-sobol-dotes-buhud-zahol-...

Looking for a way in which to install a 168 bit DES key on the Cisco PIX 520 ver 5.3(2), without having to reload the code. The only instructions I have been able to locate discuss how to do this at the time of code upgrade, but I want to leave my PI...

Hi There!On a PIX 520, I have three interface cards. OUTSIDE -- Connnected to our ISP 65.203.54.1/24 INSIDE -- A private network 20.0.0.1/24 PRN (DMZ) -- Another firm's (FIRM X) private network 56.238.64.128/26I have a conduit established from the OU...

Is there a way of limiting how many NAT traslation I could statically map to? If yes how do I disable it.I'm trying to troubleshoot a client PIX. It have been configured by somebody before and he gave-up troubleshooting what he configured.My problem ...

Does pix software version 4.2 support ipsec?

I am trying to change static command in pix 520.Currently, I have it set for (static inside, outside 172.16.1.0 172.16.1.0 netmask 255.255.255.0 0 0)This is going to allow 172.16.1.0 network.However, I am running out of 172.16.1.0 network IP.So I hav...

How can I allow all traffic from two DMZ interfaces of my 525 PIX to the inside interface of the PIX and then back from the inside interface to each DMZ? I think I have all of the traffic from the inside to the DMZs working ok but I need to open all ...

is it possible to establish a failover between the pix515 FW and the checkpoint FWI? if yes How? Thanks

I'm trying to establish a W2K pro PPTP tunnel through a PIX out to an external Multi-homed W2K server (across public internet). When I initiate the client (secure side of PIX) it contacts the external server and begins to authenticate but eventually ...

Can Stateful Failover be done WITHOUT the serial failover cable on a PIX with version 6.0? If so how?If not, has anyone extended the cable using a modem, CSU/DSU, or line driver? If so how please be specific (Products used and configuration used)? Th...