There is a listing for 5525-x ASA under product comatability for 10Gig module....I cannot find any documentation that shows the 5525-x support 10gig anything other then this listing. The spec sheet on the 5525-x don't come close to 10gig throughput e...
Hello! Does anyone know if it is possible to set up an email alert for when a user logs into an Anyconnect VPN session? Can this be configured on the FTD/FMC? Thanks
Hi Folks, Is it possible to configure the two factor authentication for the administrator in FMC or FTD without having DUO?
Hello everybody, our customer uses Firepower Service Modules in his 5516-X devices and miss the SNMP tab (see attached ScreenDump) in the FMC.That the Firepower Service Modules do not support SNMP can he understand at those are in the ASA5508-X but h...
Hi, is there an REST API command to add an IP address to the shun list automated?
Hi Community, How to get out TCP dump from Cisco ASA firewall. Spoiler (Highlight to read)ThanksAshokThanksAshok
Hello I'm new in CCNA1 course and i don't really know how to summarize a student engineering journal if someone can a explain to me how to begin with? Please How to write a Engineering Journal CCNA1 introduction to networks.
Hi Team, I am looking for more information and eventually a recommendation on the following syslog alert. %ASA-3-209006: Fragment queue threshold exceeded, dropped UDP fragment from <source-ip> to <destination-ip> on Internet interface. There's quite...
Hi, I recently created a routed STS VPN against Azure, tunnel comes up but the traffic is being dropped when the communication starts at the side of the ASA, asp captures for traffic that should go trhough the tunnel shows the following messages ...
Hello, I'm deploying an FTD v6.6.5 created as native device in a Firepower 4110 appliance as replacement for an ASA5585 with Firepower Services, I have already added the FTD to the FMCv (v6.6.5) and migrated the ASA configuration using the Cisco Migr...
Hello, I am currently unable to add FTD into FMC, each attempt it comes out with error message host x.x.x.x is not reachable. - FMC in Europe, FTD in China.- The FMC ping successfully FTD and vice versa.- I did configure network management-data-inte...
Hi All,I have a FirePower with FMC and web filtering license.I have enabled the URL filtering in the security intelligence with blocking all categories.Is that good enough?Can it perform URL filtering on https?Is SSL decryption needed for url filteri...
Hi ,I would like to delete ASA temporary selfsign cert and use our organization cert.Now asa management portal using ASA temporary selfsign cert .I would like to change this asa temporary selfsign cert with our organization cert.so let me know how to...
Hi,FMC won't let me delete a FTD device that have a L2L VPN tunnel configured. I am getting the following error, if I try. The Device 'FTD01' cannot be deleted because the following VPN Configuration(s) refer this device.Site to Site : LAB_l2LPlease ...
We can into a strange problem. As above, it's a simple S2S VPN tunnel. On our side, Node1 is primary, Node2 is secondary but connection is always established through cluster IP. There was a failover, so Node2 is primary and Node 1 is secondary. Im...
