My 3rd party cert expired on my ISE and I got another. I am just having a terrible time figuring out how to get it in and if I even have the correct type of cert
Forum Posts
Resolved! FMC/FTD NAT
HiDoes anyone have any suggestions on why I am getting NAT failures on FTD I have configured a rule allowing WLC inside to outside on ports 16666/16667 and ETHIP(97) the WLC is part of a NAT rule Natting all rfc1918 to an address.??? Thanks
Hello, I've noticed that I cant create vlan interfaces on this model but I use to be able to on older model like the ASA5505. Has this been changed ? I'm new to the X series. what's the equivalent of doing this on the 5555-X ?
Hi, I'm currently running FMC version 6.6.1 and I have two FTDs running 6.6.0.1 and want to make sure I choose the correct next step to upgrade the FTDs. When I go to download updates the only one I see for the FTDs is Cisco FTD SSP FP2K Patch 6.6.0....
I want to redundant the interface of the ASA.The equipment is a Firepower 1140.There is no interface redudant command.Is there a good way??
Hello,I am facing an issue with SSH/HTTPS management access on a Firepower 4100. After un-boxing the device, I consoled in and ran through the initial setup. I assigned the IP, subnet, hostname, default gateway, and IP blocks on the interface. I a...
Hello for everybody. Not so far away we updated our FMC and FTD from 6.4.0 to 6.6.1 software version. Today, when trying to add auto nat rule for the test network, I faced the following problem. Auto nat rules can not be configured on more than one s...
Hi All , i have installed FTD 6.2 on Cisco ASA 5508X , and by mistake i have selected FDM during installation . is there any way to convert it to FMC. Please advice
We are trying to have Duo Proxy use ISE to authenticate and not be a proxy to AD or another Radius Server. Has anyone gotten this to work before? Solution: Anyconnect VPN with DUO MFA
I have an active/passive ASA cluster. From the shell of the master unit, is it possible to SSH over to the standby unit?
Resolved! One page in ISE is keeping loading
ISE2.7 can work well. but suddenly only one page cannot be showing up and keeping "loading" status. Please see below page.Thank you
Hi! I have a question regarding DDNS and FTD. We get a DHCP address from our ISP on our outside interface which we're using for our VPN clients. We want to bind this address to a more convient name for example: vpn.example.com. I've read about DynD...
Dear community,we have recently noticed several false positives on our IPS based on Firepower Managment Center, in particular signatures: MALWARE-OTHER Win.Trojan.FANCYBEAR variant binary download attempt (1:56933:1)MALWARE-OTHER Win.Malware.Ursu-982...
Hi team,The FMC is generating the alert like below.SECONDARY (xxxxxxxx) FAILOVER_STATE_STANDBY_FAILED (Check peer event for reason)Both FTD 9300 are in HA over a port-channel. I have checked both port-channel physical interfaces are in matching the ...
Hello Communityi am tryig to do PBR flex config in my lab environment . 1. I have 2 internal subnets 10.1.1.0 /24 and 192.168.1.0/24 2. i want 10.1 should take isp-1 and 192.168 should take ISP-23. did extended ACL and tried Flex config , but getting...
