Network Security

Hi, Recently we had a problem with an ASA installed on a Firepower Appliance.When deploying the  firewall changes within Security Manager we received the message "Deployment failed due to an internal error in plugin com.cisco.nm.vms.provision.pxi.set...

I need to add about 80-90 hosts/objects into FirePOWER Management Center to build some IPS rules around them. Is there another alternative to add hosts, save for one at a time via the GUI?

All, So I have been investigating access logs on our web server and came across something that does not make sense to me. In the secure log i have batches of sshd attempts, and i know that based on the description of the log these attempts did not re...

So I set the following: debug crypto condition peer  10.10.10.1 debug crypto ikev2 protocol 127debug crypto ikev2 platform 127 However no debugs are displayed on the CLI for IPSEC tunnel negotiations. All configs for tunnel look good as it was workin...

Any word on when 6.7 will be supported for FMC virtual ?

I need a Cisco wireless router that i can use to block some certain websites and can allow some certain devices on network to access the same blocked websites. 

With reference to attached deployment scenario , need to understand on the following Failover use cases: Case 1 : Link Failure  - If the link to the Primary Nexus Switch Fails then will the secondary Nexus switch become active ? and how will the traf...

I am using a single global policy on an ASA HA pair acting as an inner Firewall. We have rules broken down into 'sections' for different solutions / systems. One rule allowed inbound DNS from DMZ to Internal DNS servers. This rule was disabled, pendi...

With reference to the attached diagram, how will the traffic switch take place when the primary HSRP Switch fails.What will be the traffic flow direction in such a scenario.. If the Firewall is monitoring PortChannel 2 for failures so in case Primary...

Hi There, I have cisco asa 5505 firewall configured as per configuration I am able to access internet.Also I configured ssl vpn but I am not able access my internal network after connection.Please help anyone to sort out this.I am not getting what I ...

Hi all, I have an FTD 6.3 on Firepower 4110.  It is configured in routed mode with "the usual" configuration: outside, inside, DMZ, and serverfarm interfaces/zones with traffic allowed out but not in. I also have AnyConnect services for remote access...

I want to keep track of the change in ACL in ASA by using TACACS+ accounting, by determining the user, command, time,...    I have the following command in ASA:   aaa-server ********* protocol tacacs+ aaa-server ********* (inside) host x.x.x.x aaa-se...