Why are we having N/A or manage under the chassis in FMC? Some will have the device's name under the chassis.
Forum Posts
Is it possible to have defined outside source-port-range in PAT depending on the source-ip-address network?E.g. Outside-NAT, using outside-NAT address 18.66.27.86.TCP-sessions coming from 192.168.1.0/24 uses port-range 30000-39000 as source-ports on ...
Resolved! FTD Question
HiI have just installed a new FTD and is now managed by our FMC I have noticed that in the device summary tab under chasis itas a url with the device name and our domain, any idea why please and how I can remove.?? The other FTDs we have have N/A un...
hi,i'll need to swap the IKEv1 to IKEv2 crypto map in a cisco 800 router.my questions:1.just to confirm, i can preconfigure IKEv2 part first, then replace the IKEv1 'crypto map' under the WAN interface during the maintenance window?2.can someone conf...
Turned off but still receiving alerts to FMC for both... the FTDs are in the correct Health policy#Also turned Cisco Cloud Support off and still getting alert on FMC..
I am in the process of setting up a new Firepower 9300. However, I accidentally misconfigured the IP block settings while trying to bring up the chassis manager, and now I cannot connect via HTTPS or SSH. How can I reconfigure the IP block to allow H...
We currently have a Cisco Nexus 93180yc-ex that houses all of the company's VLAN interfaces. To provide better security, we plan to migrate only the server VLAN interface to a Cisco firewall, and we need to sizing it. This firewall will handle: IPS, ...
How do I configure SSH sessions to TIMEOUT after 5 minutes on FTD 1K devices, I know you can set console timeout under platform policy, but what about SSH session? Is the console timeout the same thing or do I have to do this somewhere else - for exa...
Hello all, We have two physical vSphere 6.0 hosts. One is a primary host which contains production VMs and another is a backup host for backup VMs. Production FMCv is up and running on primary host and connected to two ASA5516-X physical device and o...
I have two sites one has a working AnyConnect solution 192.168.250.96 the other is not working 10.102.64.94.After review the RAVPN configuration I am sure it is correct but I have identified a possible routing issue for the AAA server. As you can see...
Hi all,I am facing a issue on cisco ASA firewall where i am able to login Firewall via SSH and able to login firewall but while i am putting the command enable after enter USER and Password, Its declined. i am using the same credentials for login the...
Hoping someone can clarify this for me.I have a FTD 1120, v7.4.2.1-30 being admin'd thru FDM. In the Networks section the values are all set at a /24 or smaller. Can Cisco handle a /17 or do I have to create multiple /24's and them group them togethe...
Resolved! SSE enrollment failure
I have several FTDs showing the same error following ASA to FTD migrationsVersion 7.2 and 7.4
Good morning everyone, sorry but it's my first experience. I purchased a Cisco 1210CE firewall, created a smart account and started the first firewall configuration. I generated the token and pasted it into the firewall and everything seemed to be fi...
When FMC/FTD 7.7 appeared, I quickly upgraded one of the lab FMC's and a couple of vFTD's. A day or so later FMC 7.7.0-89 was pulled and replaced with 7.7.0-91 with a note saying: As this is in the lab, I don't have support so a TAC case isn't going...
