Hello all, i have recently installed two virtual FTDs as Active and Standby but now i receive this error.Interface 'GigabitEthernet0/3' is not receiving any packets Is there anyway i can solve this issue and what is causing this issue please.Thank yo...
Has anyone noticed the high degree of "Background Intelligent Transfer Service (BITS)" traffic is coming through their FWs? I've read up on what it is and wondered why so much traffic is hitting the FW and what is being transferred. I came in this ...
Hi Sir: What event will trigger any session to log the Reason type of "Intrusion Monitor". The Firepower just think the session is not really hight critical and it will not compromise our client. So it will log of Intrusion Monitor , Right ? Or it...
Hi Pros The biggest problem now is with the ASA firewall we have no idea on how to configure them to achieve a connected network. Our ping test from Router and Users fail to reach the DMZ interface. I assume that we have to configure static routes an...
I am trying to setup for the first time a CISCO ASDM 5510 that I recently bought from 2nd hand. My plan is simple:e/0 (outside) no income traffic allowed at alle/1 (office) my home-officee/2 (servers) it is my home lab I have some servers there and I...
Is it posible to stablish a site to site vpn between 2 remote located FTD's without a FMC?
Hello, I am unable to find the included and the max. numbers of users and VPN peers for the new FPR1010-ASA-K9. (ASA Image) Thanks a lot in advanced. EL.
Hi all Does anyone know how to globally set SSH access list? I have Cisco FMC/FTD 6.2.3.x There's no setting for it from the platform settings sectionI tried to use flexconfig bu "configure ssh-access-list" is a blocked command... Any ideas greatly a...
Trying to find out when the HW EOL date is for the 2110 ASA is.
This is a VERY simple setup. The ASA is running in transparent mode with an inside and outside interface. The ACLs allow ip and icmp any/any. But every couple of minutes you cannot ping through the ASA. The 1800 router goes out to a WAN.1800RTR--...
Hi everyone, Not long time ago started to see such problem. I'm using the default ASA firewall config (inside is 192.168.42.253/24) and setup the FirePower module to use 192.168.42.203/24. I can ping the FirePower module from my PC and from the ASA'...
I have a scenario where traffic from Site A to Site B takes place via NAT... now the requirement is to put this NATted traffic in a VPN Tunnel created in Cisco ASA/Firepower. When i try to create site to site vpn tunnels it gives an option to exempt ...
Hi, after update the ASA image, I've noticed the following messages/warnings after reboot:(I use the following ASA image: asa984-15-lfbff-k8.SPA)Configuring network interfaces... done.Populating dev cachedosfsck 2.11, 12 Mar 2005, FAT32, LFNThere are...
HiThis is probably a really simple question ! - I have a Cisco 5545 which i'm accessing via the cli which is already fully configured.I recently entered a 'command show running-config | b crypto' so I could take a look at specific crypto configuratio...
I need to take CCNP 300-206 before February 24 and take the core exam after February 24 2020 is there any prerequisite i have to take before February 24 and also according to the new policy i need to have Cisco Certified Specialist - Web Content Sec...
