Network Security

Hello Community, I have a ASA with a local VPN Pool where the VPN users get their IP-address. Is it possible to advertise this network in the bgp process? Thanks and regards,Philipp

I have eStreamer setup to forward logs to our Splunk instance; however, I am not receiving any packet data. In the TA-eStreamer setup I have "Packets?" checked.In the FMC eStreamer Event Configuration, I have "Intrusion Event Packet Data" checked. Si...

Hi, From our Firewall PALO ALTO, I try to get informations from ISE SNMP logs in order to identify users connected to ISE, to give them access to ressources.... I need to be able to link Username and IP address...   Then, I get info from this log : (...

we can not run or launch asdm on asa 5506-x

Hi,   I am trying a very simple CA set up as below   R4 Fa3/0--------------Fa0/0 R2 AKA CA SERVER   Below is the debug o/p from R2 while executing the command "crypto CA authenticate <trustpoint-name>" in R4 May 18 11:23:14.383: CRYPTO_CS: received a...

Hi All,   I am getting below error while trying to enroll certificate from CA server. "ERROR signature public key not found - abort " My CA server is Windows 2008 server & i have configured trust point in Cisco ASA firewall.   I am able to authentica...

Kindly,   I want to block a particular site, example:   1- you-tube.com (it is a domain, but I do not want to block all you-tube domain) 2- https://www.youtube.com/watch?v=3oRSzE5RIuc( I need to block only the part of this site not all domain)   How ...

Am Receiving detections : FILE-EXECUTABLE McAfee LiveSafe malformed executable denial of service attempt (1:39463:3) But Mcafee is not used on the network.  Can this be disabled if not used on the network, or is the signature doing more than just pro...

All I have following configuration: interface VirtualPortGroup0 ip address 192.168.200.101 255.255.255.0 Interface VirtualPortGroup1 description Data interface ip address 192.168.0.1 255.255.255.0 virtual-service myips vnic gateway VirtualPo...

Hello All, How to efficiently migrate ASA-X configurations to Firepower 4100 (ASA Image)? In case we use FTD image, FMC and the migration tool are very helpful but what if the installed image is an ASA? Note that the ASA-X was not running the Firepow...

Dear all, I have 3 FTDs 2100 version 6.2.3 connected and configured by Virtual FMC (6.2.3). Two of the three FTDs are configured in HA mode as per attached. I want to break the HA in which FTD_02 which is the active (as attached) keeps working and pr...

Hi Team,   We have anyconnect configured on ASA 5508-x with windows radius(NPS). We are trying to add multi factor authentication with Google Authenticator and Corporate asset validation with registry entry using AD environment.   Currently from any ...

Hi all, I am trying to add my cisco firepower 2130 appliances to my FMC. According to the link (https://www.youtube.com/watch?v=eshXpBPPKPg), from the console CLI, after entering the default username and password, it should prompt me to accept EULA a...