Other Network Architecture Subjects

I have cisco ACS version 5.5. and i have installed the TACAUS server. unable to reach TACAS from console. the i had done troubleshooting changing RAM  slots able to reach application. but i am getting error overall server status severe FaultThe thres...

Can someone help me how FireAMP do any behavior-based detection with and without Tetra? Any help is highly appreciated. 

I need help with this setup. Sorry if im doing something stupid but im just learning. So I have this 3 networks that are supposed to be in three different cities. But my teacher said we should connect them using the same IP address distribution for a...

Hello, My default class-default is not using the traffic shaping and queue length that i have configured.  I configured a parent policy map (Out) and a child policy map called (MPLS_Out).  The parent policy map provides traffic shaping for my MPLS ci...

Hello,I would like to know if there is a way to prioritize some process over others when CPU usage is close to 100%.For instance, prioritize BGP or PPP processes so that WAN connectivity is not lost during peak CPU usage. Thank you.Thomas.

Hello,I am configuring some flexible Netflow records on my ASR1002-X (with IOS Version 15.5(3)S4b) and ASR1000 routers (with IOS XE version 16.3.5), and as I'm doing sampling (to preserve CPU), I do not have a reliable information on bandwidth usage....

I create Vlan 1, but see Vlan 1 is down.#sh int vlan 1Vlan1 is down, line protocol is down.can someone explain the reason.Thanks.

Hi,We had an activation fail yesterday due to what I am told is interface limitations on the ISR 4331/K9 but I believe I am correct with my initial assumptions and equipment but would like to confirm. Cisco 4331/K9 2 - SFP1G-LX-31 LC SFPs The cabling...

Hi,I am in need of the 16 console port terminal router for small office. Please suggest the model number. Thanks 

HiPlease note i want to configure my Cisco ASR 1001 as a DHCP Server which can handle DHCP Clients Request with DHCP Option 82 forward from a DHCP Relay Agent. I can confirm the relay agent add the correct RID and CID on the DHCP Request packet but l...

Greetings I have an ESXi host that sits behind an ASA. For several servers on this host, I wish to expose them to the outside via NAT with a public pool of IP addresses and control access via ACL. The ESXi host is attached to a 3850 stack that's usin...

Hi,Anyone can help me? I have a new router and I started configuring. I always get these annoying messages%Error opening tftp://255.255.255.255/network-confg (Timed out)%Error opening tftp://255.255.255.255/cisconet.cfg (Timed out)%Error opening tftp...

Hello, I've got AIR-CAP3602I-E-K9 (Cisco Aironet 3600 Series) and I'm trying to set up DHCP server on this device without luck. Every wifi client connected to this device gets IP address from the router (access point acts as a relay). What should I d...

HiHaving trouble resetting the baud rate to 9600 on a 3750-E.  Basically the device cannot be set to anything other than 115200 baud rate.I have changed this via startup-config (which lost connection) reconnected and saved config but after reload was...