Other Network Architecture Subjects

Deo any one have OID to check how many packets/sec is getting in and out on a interface

Good Day, It seems this specific switch does not have a 'sh mac' command? only 'sh mac access-group' which do not show MAC to interface, 'sh ?' does not indicate a 'sh MAC' Any advise? Regards        

I have few a  Catalyst 9300 with as VTP clients and Catalyst 4500 as a VTP server.As I understand, pruning enables passing of certain VLANs on a trunk port only if they are explicitly assigned to its access(end-point) ports, but when I run "show inte...

Hello Guys,I am trying to establish S2S IPSEC Tunnel with 2xHSRP routersPrimary Router connects to the remote site over Primary link and the plan was to introduce a secondary router connecting to the backup non prod Backup Link so if Primary Router i...

Hi Guys,  Which console can be used on this router? On CCW Cisco suggest this console: CAB-CON-USBRJ45 Below is the console interface  

Listen here: S11|E13 Master Network Analytics, Assurance and Security with Intelligent Capture Packet captures are an invaluable tool for network teams, yet the traditional process of capturing can be manual and cumbersome, turning what should be an ...

Listen here: S11|E11 Cisco Validated Delivers Value Part II Did you notice that Cisco Validated is now at the center of Cisco.com? Do you have the responsibility to prepare, plan, design, implement, integrate, secure, and operate IT infrastructure? I...

After EOL of most devices, will the new devices all change to SDAccess and SDWan? will campus network devices be deprecated that force whole world change to SDAccess and SDWan?will spanning tree , multiple spanning tree , VPC, load balancing mac dest...

I have the following configuration on a Cisco 9300 : interface TenGigabitEthernet1/1/1switchport access vlan XXswitchport mode access!interface TenGigabitEthernet1/1/2switchport access vlan XXswitchport mode access!I have two PCs connected to those i...

Hi AllI have cisco ISR4431/K9 router logs below. what is cause root for the following notifications?024719: Nov 7 09:42:23: %IOSXE_QFP-2-LOAD_RECOVER: Slot: 0, QFP:0, Load 29% recovered.024720: Nov 7 09:42:38: %IOSXE_QFP-2-LOAD_EXCEED: Slot: 0, QFP:0...

I replaced our home Netgear router with this Cisco unit, and it is behind the AT&T gateway.The Cisco has all ports on VLAN1 in Trunk mode using overload to port 8, and it's performing well, except I'm having trouble with some of our smart devices sin...

Bonjour,Je précise que je suis débutant. Comment est ce possible de lancer un ping depuis un switch sachant que le switch est de niveau 2 et  ne construit que des trames de niveau 2 avec la mac source et la mac destination. Du coup il manquera l'ip s...