Other Network Architecture Subjects

model WS-C5505show logging bufferthis error message is what ????2004 Jun 12 01:32:40 %SYS-3-P2_ERROR: 3/Watchdog failure (Standard Watchdog Funnel) - system may reset 10.1.13.52004 Jun 12 01:32:38 %SYS-3-P2_ERROR: 3/Watchdog failure (Standard Watchd...

I just installed a new CiscoWorks Wireless LAN Solution Engine (v 2.7) and the install (with command line) went fine but I can not get the web interface to load. I get the login screen for both http and https, it logs in but it just keeps refreshing...

Basically, I want to redirect everything that hits our outside IP address of our cisco 1720 to an inside address (our firewall is sitting behind the cisco). Basically I have no need for the cisco to do anything but pass traffic, but need to keep i...

I'm trying to advertise the default received from eBGP peers to iBGP peers but I do not want the iBGP peers to receive all the other routes. What does an access-list that matches a default route look like? Thanks in adavance for help.

I am trying to find the command defined on the Cisco Site. I find plenty of listings in sample configs yet no command description. This is in a Cisco 3640 router. Thanks for your help.boot-start-markerboot-end-marker

Hi All!Two SPAN-ports do not work for me simultaneously.My config:interface FastEthernet0/1 port monitor FastEthernet0/2 port monitor FastEthernet0/5 port monitor VLAN1!interface FastEthernet0/2!interface FastEthernet0/3switchport access vlan 2!inter...

Does anyone have any examples of configuring ISO-IGRP over an ATM to Frame network, using sub interfaces on both the ATM and Frame interfaces ?

Hi...I want to apply AAA Auth-Proxy at Cisco 2621 in my customer. I've used IOS software with firewall feature to implement it. The question is, how many user that can be authenticated using this mechanism? Is it true that we can only use 40 users a...

Hello, I am trying to troubleshoot a slow WAN link between two sites (I bet you've done quite a lot of this).It goes like this SITE A [Cat 5500(10Mbps/full) - (10Mb/full) 3745 (2 DSU WICs)] -(2 p-t-p T1s) - Site B [(2 DSU WICs) 3745 (100Mb/full) - (...

Hello,I want do traffic shaping on my 2600 series routers.At the central office I have 7500 series routers.This is my first time configure FRTS. Can you tell me how to do this? What commands do I need to enable from both routers?Thanks

Does community string indexing method to work on CAT3500XL with IOS 12.0(5)XP. I am having trouble seeing devices connected to vlan2. Switch is not responding to commnad snmpwalk -c community@2 switchIP mib-2.17

Does anyone have a sample of access-list for allow a specific MAC address to access the network? In order words, something like:"access-list permit [MAC address]" It is for a simple PC only.Thanks

How do you document where your cables go? Right now we have notebook with each floor plan in it and we hand write the location of each jack on it. There has got to be a better way. Any ideas would be very helpful.Thank You

Is it possible to have some form of SNMP configuration (so a ticket or e-mail or something would be generated) when the following occurs:%CLNS-5-ADJCHANGE: ISIS: Adjacency to XXXXXXXX (GigabitEthernet4/0) Down, neighbor forgot us%CLNS-5-ADJCHANGE: IS...