Other Network Architecture Subjects

Hello, i've got a problem with IOS management. I've downloaded the IOS on the Cisco 881 Router, but then i had to break the download and i forgot it. Next time i deleted the operating IOS and then booted the router and ofc. it jumped in to ROM Monit...

Hello, I have an issue with cisco switch 2960, the color of ( SYS LED ) is red but when i turn off and turn on the switch the color of the LED became green but when i trying to login to the switch via (Tera Term) this message pop up ((( CPU rev: B ))...

Hi guys, sorry for the silly question. How do we remove the interfaces that were added to the port group "WAN" of the "System Defined" group? We added the interfaces by following this procedure: http://www.cisco.com/c/en/us/td/docs/net_mgmt/prime/i...

Does Cisco have software to utilize with the serial connection that I can down load and use to set up my 3750g-12s

Sample config below: System image file is "bootflash:asr1000rp1-adventerprisek9.03.15.00.S.155-2.S-std.bin" ip access-list extended to-Tunnel1  permit ip host 10.0.0.1 any  permit icmp host 10.0.0.1 any ! class-map match-all to-Tunnel1  match access...

What do I need in order to download licences, software, updates? In order to generate licences for Anyconnect usage, what is required? Thanks in Advance

I have a 6509 cabinet with two 48port POe switches modules in it. My issue is when the power goes out in the building and the cabinet restarts , the modules have to be powered up manually after the cabinet/sup comes up. Is there a cli to autostart th...

I have 3 context on asa. and I cant open ASDM from brauzer. I have asdm.bin on asa. I enable http server. I can connect via ssh with putty. write my host ip address to asa. Please help :(. and sorry for my english

I need to design the network for a campus having around 20 different location/buildings and these connect to the centralized data center where 6513 switches are working in VSS with 2T supervisor engine.Access switches considered as 2960 and its a POE...

Hi Guys, I have to setup a Lab to refurbish 2000 switches and routers I was wondering if there is a method out-here I can use to factory default at the same time at least 10 switches or routers because the time I have to do the job is very limited an...

Hallo Community, Ich besitze ein NMH410 mit der Firmware 3.18.15. Nun möchte ich die Einstellungen des NAS anpassen wozu ich das Passwort eingeben muss. Ich gehe dazu auf den Menüpunkt Konfiguration. Nach Eingabe des Passworts erscheint folgende Meld...

Cisco 4351 ISR. The 4351 has visually confirmed two DIMMS, a pair of 2GB. I can't tell which is the onboard flash or an MMC of 8 or 16 GB. However, when I calculate the DRAM from show ver I get 1687137K/6147k, add it up, 1,693,284K. Multiply t...

I started turn on the 3750 Switch, and i saw that again and again for one hour thanks for watching! all output console in the file: Note.txt

Hi Can anyone tell me why the brackets for the 2900 series routers ACS-2900-RM-19 have been changed. They used to have open ends so you could mount the cage nuts then lift the router on, then tighten on your own. The new brackets are closed so you h...