Other Network Architecture Subjects

Hi all, I am wanting some help with bridging. I have two Cisco 2600's with a 1meg leased line in between, i am using 15 channels of primary ISDN as a backup. there is a system called a tandem at each end of the leased line. these two pieces of kit ne...

Hi! I have a router 760, and i need to know the users connected to the router or the users u make the calls.Can some one help me?Thanks.Pedro Guerra from Portugal.

I want to implement traffic shaping in a Frame Relay network (partially meshed topology) using layer 3 protocols as a priority factor, what would be the best queuing method?, also, could anyone give me a good reference?, sample?.Thanks!Xarold

when configuring a 2500 series router e0 interface with with three different IP subinterfaces and one network Novell IPX, could u include the novell configurations on the e0 interface as a secondary config? Or do I need to add another subinterface?A...

Two Sites connected with a leased line (2Mbps). Site 1 has Internet access (512kbps) and both sites access to internet through that Internet access.I want to reserve 128kbps for site 2 and 384kbps for site 1.I mean , I want to make sure site 2 can h...

Could any one here explain the binary tree process in fast switching preferably with a pictrorial presentation.Been through the URL "http://www.ieng.com/warp/public/105/20.html" ,not adequate for indepth knowledge.All usefulURL's Welcome.Thanks,...

I have 4 T1's already configured and working on my 3640. We now have added another office and have a Cisco 1720 in there. I want to configure the 1720 and the 3640 so that the other office can share our internet access. How do I go about doing thi...

Can anyone help me to configure VLAN and VTP in Cisco 2900xl switch??pl reply to rajagopal_s@satyam-infoway.com

Can anyone help me? The problem is I have 7 routers connected via leased line and I cannot use any IP of serial interface (every router) for telnet into the router from any PC, but if I use IP of ethernet interface for telnet session then it's ok. I ...

I'm currently implementing a remote network management system for the radio equipment product that we sold to one of our customers and it involves the use of Cisco routers 2600 & 3600. I'm a newbie in Cisco products (just studied the IOS commands for...

Hi,I have a problem with 7206 VXR with I/0 one fastethernet, NPE-300, the modules are 1 atm oc-3, 1 GBIC, 8 E1 multichannel,and the ios version is 10.0.9(s). when I try to ping one of the interface, point to point to the router, I always got the inte...

by mistake a file from tftp server was copied to flash that is not flash ios. i was at rommon comand and tried the tftpdnld with no success. then tried the commandsrommon 1>MONRC=BOOT=flash:,n; rommon 2>sync rommon 3>reset (n= 4)what ha...

Kindly suggest a way on how to configure my preexixting 3660 router configured as pri ras(for aaa of isdn calls) to also accept normal pstn dialup calls.since it can support 30 simultaneous isdn user logins, i want suppose 15 slots reserved for isdn ...

Hi,Is there any way to do IP masquerading in a cisco router. I have a class c network of 8192 nodes. I want my ISP to recognise each request sent by any node in my network as requested by only ONE IP. Is this possible?Thankskanwaljeet

Can someone explain to me the differences between the Basic and Enhanced versions of WebNS software?Other than the global features I see both packages as being the same.