Other Network Architecture Subjects

Is there a way to apply a connection filter with the highest priority that would block all specified traffic (via the deny filter) to all connections? The goal is to avoid having to apply 30+ deny filters to many different already configured connecti...

a partner is requesting for a cisco1941/k9 with ip service i know that this router comes with ip base. so how can i achieve the ip service licensing? br samson

hello All! I have a Internet provider that offers IPTV and Fiber internet. We have an internet router and we also have a Cisco VEN501 that goes to a Cisco Set-top box. They are both wired up with Ethernet for the provided box outside. Here's my quest...

Hi veryone , can you help me how to resolve this problem with my switch 3750x 24S , when I boot up and it has this message below  , what should I do to resolve it? *Mar 1 00:01:16.856: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0, ch...

Hi,  I want to confirm if Cisco 892FSP router is running only Advanced IP Services license (which includes Security FL), is DRAM upgrade from 512 MB to 1 GB mandatory? Documentation on Cisco 892FSP says RAM/DRAM upgrade is required when WAAS is conf...

Hi Team i'm struggling with information and setup of the Aeroscout industrial system evaluation demo kit. In addition to this the L-AD-LS-1AP-N needs to function. the design was put together by Cisco but the correspondence lost. The KIT has now arri...

Could anyone explain the following: Application layer functions typically include identifying communication partners, determining resource availability, and synchronizing communication. When identifying communication partners, the application layer...

Hi, I have a UBIQUITI UAP-AC-PRO needing 802.3af POE/802.3at POE+.  I have connect it on a 4507 with WS-X4648-RJ45V+E card.  The description says: "WS-X4648-RJ45V+E Cisco Catalyst 4500E Series 48-Port 802.3af PoE and 802.3at PoEP 10/100/1000 (RJ-45)...

Please how do I show the passive interfaces in the following network based on Advanced EIGRP Named Configuration Approach, apart from using the "show run" command. When I set up the network using the Basic EIGRP configuration and issue the "show ip p...

Good Day! May I ask which 10gb sfp is compatible with our cisco switch 2960x series switch ws-c2960-24TS-L Thank you very much June Charanguero

We have an ASA 5550 on DC Power.  The manufacturers label on this unit recommends a 2.5 amp fuse.  We have had a 3 amp installed actually but it has blown out twice since Nov '16.   However two documents I have found on these units seem to imply 10-1...

Is there a way to see a forgotten pin number for voicemail or to reset without the number?

We have Cisco ISE 2.0, which we are using for Wireless authentication using Active directory. We are looking to implement tacas+ authentication for our Network devices as well, but we dont want to use AD which is used for Wireless. I could see we ha...

We have a number of remote sites connecting to headends via IPSec encrypted GRE tunnels over the public internet. Our current configuration works, but we would like to see if there is a better way of handling the no-split tunnel rule. At the headend...