Other Network Architecture Subjects

Hello All, I am currently debugging subscriber error in an ASR, and see the following message pop up. "SSS MGR: Error Invalid Lterm Session handle" I have tried to look for this error message but have found no results.  Can anyone assist that would b...

Trying to setup a Cisco 2504 controller for AP- AIR-CAP3702E-E-K9The controller is up but the APs can not Join.below are messege from the log file:LogSystem TimeTrap0Wed Feb 18 17:51:42 2015A RF group member has been added on 802.11b/g network on con...

Hello Cisco Gurus,Here is my problem...I am using old 2509 router for my ccna practice, connected my router using consol cable with usb adapter and using SecureCRT for CLI.All are just fine and I cqn play around within router.Now I need to upgrade IO...

Dear Support Members, Can anyone assist with the procedure of setting up ASA to failover two ISP links if any of the ISP fails.   Thanks   

I nee to see a picture of what connectors the cab-bs1363-c19-uk has

Hi, I have a costumer with a WLC 2500 controller and a guest-solution with a radius server that only supports PAP authentication to the radius client (WLC). How can I make the WLC talk PAP to the Radius server? It looks like the controller uses MS-CH...

Connected 2960x uplink using SFP ports both stacks and all 4 ports worked good.Remote tech connected last stack cable between first and last switch, in 2 different 2960x stacks of switches, while switches were  powered on. A longer stack cable was ne...

Due to throughput limitations, I would like to upgrade from a ISR 2851 to a ISR G2 2951.I would like to know if the configuration can be exported from the 2851 and loaded to the 2951.Is there configuration compatibility or will I have to manually re-...

I have a park area that requires POE cameras for security and wireless coverage.  It is an outdoor park and the distances in some places exceed 100M.  I was looking at POE extenders, but have read the Cisco switches have an issue allowing the extende...

Recently, I have had users on many controllers using many SSID's with various security, even open, show a consistent 5 minute duration for their association. It is the weirdest thing. No changes have been made and this could be phones, laptops, table...

I have an RV220W and have VPN connections to my clients office using IPsec (and they are using RV220Ws as well).I am able to get the connection established and working for most of my clients, but I have one client that has the same subnet as another....

What is the boot sequence for an ASA 5525-X. How long does it take to boot up from power being turned till it is passing traffic.

I am looking for documentation which outlines and specifies how Cisco VTC Codecs meet HIPPA compliance.  I need this documentation from Cisco to provide to an enduser client looking to use Cisco based hardware for VTC Calls that need to be HIPPA Comp...

My organization has multiple 4500 series switches experiencing the same problem when attempting to authenticate devices via MAB.  The issue is that the "show mab interface fax/x details" shows the Client MAC in a waiting status.  The device is never ...