Where´s possible download the Cisco IOS for the Supervisor Engine and MSFC version 12.2(9)YO3 or another ?I look in the downlaod page and this ios is not in list for download.
does anyone know of a link that will show all the different syslog messages you can get from a router, switch, or pix? an index with the errors listed would be nice. your reply is much appreciated!
What is the difference between these two sup modules for Catalyst 6000/6500.(WS-X6K-S1A-MSFC2) Catalyst 6000 Supervisor Engine1-A, 2GE, plus MSFC-2 and PFCand(WS-X6K-S2-MSFC2 ) Catalyst 6500 Supervisor Engine-2, 2GE, plus MSFC-2 / PFC-2
Does anyone know how to configure ciscoworks2000 to page me if a device goes down/unreachable. I have ciscoworks setup to page PRI 1+2+3 alarms, however cannot figure out how to make it page when a device is not reachable. Ciscoworks can run reports ...
I have an application that has a long delay and slow load... up to 5 minutes at times! Other things loading or copying over the network seem ok so initially I just thought it was something with that app. However I would like to know for sure that the...
I seek a Cisco Layer 3 swicth that meets the following requirements:1. NEBS Compliant2. DC Power, pref dual redundant supplies3: Layer 3 capabilities: A: IP Routing including OSPF area participation B: IP ACLs that operate at line rate C:...
i am trying to install and configure a new setup. i currently have 1 point-to-point T1 from our office to our hosting facility. it has been decided to move to 4xT1s from our office to our hosting facility, and for certain reason out of my control i...
I'm unable to console to a 1604 router. At first , I seemed to have lost my ethernet interface - no ping response. Know I'm trying to access the router to see what is going on and I can't. It will not allow me to console into it.
Does anyone know how i can run a debug to check whether WINs traffic is passing over the wan link ok.I have a remote lan which is picking up dhcp leases ok & clients can see network neighbourhood but they cannot map drives or see the connected drives...
Have a firewall set up with Filtered HTTP traffic - if you're IP is not in the list, you don't get through on that port. Proxy servers are set up with internal interface of firewall as default gateway. All users on network minus IT professionals are ...
Hello,I want to pick up a 1601 to use in a lab to study for certs. I have no use for the serial port but, I could use 2 ethernet ports. I know the 1605 has 2 ethernet ports but, it is significantly more expensive. I was curious if there is a device t...
This is probably a newbie question but I haven't been able to find any configuration samples. I have a small site that is using a partial T1 for internet connection. I need to setup a backup connection for when that goes down. I have an extra wic-1a...
I would like one remote location to call a second remote location when its frame relay is down. If the second remote location goes down it too will need to call corporate for dial backup.Having the first location call the second location, I will save...
I'm intending to set-up BRI back-up from our customer sites using 'floating static routes'.Is an individual subnet required for each BRI peer or can a single subnet from the main host be used across multiple BRI peers? Example:Host Router host123:int...
