Could anybody please explain what BGP Attributes are and how they are used?I believe that they are BGP's way of making routing updates incredibly flexible and granular, but am not sure.Any help would be great.Thanks, Dan
I enabled SNMP on a few Catalyst 2950XL with 22MB Flash, 32K Flash.Whenever I'm working on CW2k server (esp RME and Campus Mgr), the switches always reload themselves. Does it means that the device has insufficient resources? Pls help, thanks.
Help!I have 2600 connected via individual serial links to 3 1600's. They all hook into ADTRANS. They upped the bandwith to 6 channels. Now all my links are down.None of the routers have a clockrate configured to begin with that I could see on a sho r...
there are 5 routers on the lan, two of them have wan links(bandwidth is same),one router is elected ospf dr router(has wan link),another router(has wan link) is not dr and bdr. if there are networks whose cost to two routers are same, will another 3 ...
Okay guys, I'm having a problem here and can't find a definition of the error/explination of the problem anywhere.I have a Cisco 2611 running IOS 12.0(7)T and a Cisco 7206VXR running 12.2.(7c). I want to run EIGRP between the two. I have a PA-2FE-I...
I am attempting to configure a multilink bundle between a 1760-V and a 3640. The serial interfaces come up correctly, and the Virtual Access 1 interface is created and up, but it does not take the IP address settings from the Virtual Template. The ...
Hi There,Is it possible to connect and configure isdn bri leased line on serial interface. The router is cisco 2600 with wic-2t? Do I have to have isdn bri card in cisco 2600?Thanks,Suneel jain
We have cisco3640 router which is loaded with IPv6 flash image, suddenly it went off the network and when we switch OFF/ON its console come up with "rmon1>" prompt, then again we loaded the Ipv6 image "c3640-is-mz.122-2.T.bin" (previous image was als...
I have Ciscoworks 2000 on Solaris using release 4 of CD 1. I am trying to get RME to synchronise with the rest of Ciscoworks (a common problem, I think). While wading through the documentation I came across many references to things that work with Sy...
Hello all,I have two 2600's that are having an unusual problem.I can ping from Router A to Router B, & but I can't do anyTCP i.e. Telnet, SSH, Traceroute, etcRouter Ainterface Multilink1 ip address 192.168.1.1 255.255.255.0 ip directed-broadcast ip ...
hello,i have two BRI acces in my headquarter (using cisco 2600, IOS ver:12.0), and four remotes sites (using cisco 1600, IOS ver:12.0) with one BRI acces.the probleme is:i can't have a 4 simultaneous connection from my headquarters to the remotes sit...
Can anyone please say, how can I find the capabilities of a FastEthernet port on controller card of a 7206, like if it supports VLAN, trunking, etc.I have alreday searched all the product documentation was not there!Thanks,Mohammad
I have a 5530 NFFC III. It appears DOE, when we start it we can't even get a console port. When the power is turned on the switch shows all green, then when the power up is complted the activity light goes red. Does anyone have a suggestion as to wha...
