Other Network Architecture Subjects

When my ASA5505 starts it loads into rommon. I enter "boot" and everything boots fine. How do I make that load by default whenever it starts. Does anyone have the correct command syntax to make that happen?Thankshere is the output from the entire boo...

Hello.I am looking to upgrade an 1812J router to 1921/K9 router with 8-port double wide switch port.One of the main reasons for the upgrade is because during the when we have internet music streaming on some devices, it cuts out when the traffic gets...

Hi All,Just want to ask if 4-port serial HWIC-4T is compatible for the Cisco 2801?We need additional HWIC for Fast Ethernet but the problem is we don't have already slot for it.We already have two HWIC-2T 2-port serial which is inserted at slot 1 and...

Hi all! We are going to "publish"(I don't knowif this is correct word to use;)) our mail server on Cisco 2921. As far as I know it can be easily achieved with static NAT. But the thing is, we don't want to publish it on standart 443 port i.e. we want...

Hello, Actually i have problem with my connection and i would like to find that problem.i have 3 sites(1,2,3) connected together through fiber multi mode cable. The site 1 having the control room, the maximum distance between site (1 and 3) is 1.8 Km...

What OID is used for ASA firewall to monitor CPU? Cisco Adaptive Security Appliance Version 8.0(5)19 I understood CPU utilization is monitored from the  cpmCPUTotal5minRev OID 1.3.6.1.4.1.9.9.109.1.1.1.1.8. part of the CISCO-PROCESS-MIB.  In the abse...

My CCNP / CCVP is about to expire. Am I write to say that I will be recertified in BOTH - CCNP and CCVP -  if I pass anyone of the following exam?642-902 ROUTE Implementing Cisco IP Routing (ROUTE)  or642-813 SWITCH Implementing Cisco IP Switched Net...

I am looking for (free) templates for documenting network infrastructure (Catalyst 6500, 3750, ASA 5500).I am not looking for a software.

Hello All - I'm trying to get my 2811 router to boot from USB Flash...I've copied the appropriate IOS Image to the USB Flash drive and added the command "boot system usbflash0:c2800nm-adventerprisek9-mz.151-3.T3.bin"I've upgraded the bootstrap image:...

Hello,I would like to know about the test strategy and testing plan for customer requirements of Switched network involving 2 distribution and 2 access layer switches. What could be the test strategy and test plan for customer requirement - configure...

Hi,i have two routers R1 and R2 connected by EBGP.The configurations in R1 isR1#sh runBuilding configuration...Current configuration : 589 bytes!version 12.2service timestamps debug uptimeservice timestamps log uptimeno service password-encryption!ho...

Could you help me with one question? I have cisco 7206VXR-G1 router, it using two interface to connect to others Autonomous systems (Using BGP). There are couple a peers on this interface. Can I change Interfaces IP address and subnet number? Will BG...