Other Network Architecture Subjects

Hello,While adding 4700 with IOS 12.0(12), to the RME we get an error message;"Check DB status (running/stopped). Check DB tables for missing or NULL key value columns." with other routers no problem.The RWAN documentation states the software support...

Good Day All,I am troubleshooting a CiscoWorks 2000 server running on HPUX.When i open up the gui, all of the devices are gone from device views.I have also found the following error under /var/adm/CSCOpx/logINFO: CmfDbMonitor: Execing '/opt/CSCOpx/o...

We are in the process of converting our existing routing infrastructure from a Frame Relay, T-1, 3Com router based WAN to a full blown Cisco IMA WAN with a 7206VXR core router with 3640s in remote offices. The 3640s have 4-port IMA cards with 3 T-1s ...

I've noticed a very strange Cat4006 boot behaviour:After switching it off/on there was an old config version loaded. It seemed like not all config changes I've made during some time were saved. I'm running CatOS 7.2(1), Bootstrap 5.4(1). sh boot out...

I am almost positive you can not do this, BUT can a sup III engine from a 5500 go into a 6509? And if not ( more than likley )Does the Sup I engine for the 6509 do layer 3 routing? Thanks

Our customer's 6509 complete with dual MSFC2s (WS-X6K-SUP2-2GE) plus PFC2s (WS-F6K-PFC2) do not appear to be destination flowing but rather flooding to all ports.Only by adding mls rp ip to an interface did the MSFC suddenly append the following outp...

I have a situation where I am trying to route traffic through one Internet link (C2600 router connected to Broadwing Communications) to a Web Server on a DMZ located on a redundant Internet link (C1600 router connected to Cable and Wireless - C+W). ...

I have this situation that goes like thisWe have a network 10.10.10.0/24 ( VLAN 10) and 10.10.11.0/24, 172.30.0.0/16 secondary( VLAN 11) as vlan addresses which communicate with each other via MSFC.There is another network 10.104.0.0/16 on another r...

How much NVRAM is required to support a WS-X5225R card in the CAT 5000 switches

Is it possible to bundle 2 serial ports with 2x 2503 routers?at the moment i've got 2 2503 routers with a 2Mbit leased line and was wondering if its possible to get a second 2Mbit leased line and bundle them to make 4Mbit.thank for your help!!

Dear all,I want to ask if I had a frame relay VC between two routers in a frame relay cloud , and these two routers are not connecting to the same frame relay switch , if one router goes down did the other router will sense that the router is down in...

Hello,I have a problem with a Cisco 826 router and nat.Until now, we had the following network:INTERNET | | | |FLOWPOINT ROUTER : External IP 217.136.183.122 | Internal IP 192.9.100.1 | | | | | |MULTITE...

Anyone can help is there any Network Management tools can help to monitor and alert the administrator about network botleneck or node failures.Please guide and give more info on the CiscoView and CiscoWork 2000.Please help out..

We have a 72xx router connected to a 36xx router via a 384K international leased line. I have observed that under heavy load the 30 secs output rate under the 72xx serial interface could reach and even exceed 500000 bits/seconds. The "received clock"...

How often do LSA entries age out on a cisco router running ospf by default?