Other Network Architecture Subjects

Looking to assign multiple IP's to the LAN side of a dsl cpe on the end of an atm pvc aal5snap via a 7200 router running irb or rbe. Is it possible to assign several consecutive ip's from the bridge group to one device other than sereral host routes...

We have a 1720 with serial port and one ethernet card. Used to provide frame relay internet access to internal networks. 192.168.0.0. I Would like to provide routing to additional subnets ie 192.168.1.0 Can anyone help with configuring a 1720 router ...

In Cisco1750 router with c1700-sv3y-mz.121-3.T IOS, added one E&M voice card in the WIC Slot 2. After booting the router checked with show version and show run command there is no identification for E&M card. But checked with show diag command is gi...

Experts One of our client (a Little Service Provider) use a 7204vxr as there Internet Access Router, they use NAT for their clients, but recently,the router is always suffered by High CPU Utilization, when they use thecommand "show ip n...

I have tried distribute-list,but it didn't seem to work for OSPF,but it does work when using EIGRP.

I've setup a frame relay network with ISDN routers for their backup internet connection.Basically, I used HSRP on two 1720's at each remote site. One 1720 is used to connect to the frame, the other is used to connect back using ISDN. If the frame i...

Hi..when i try to give a IP address to a subinterface in my cisco 3600 it gives me a message that "subinterface should be a part of 802.1q ,iSL, or Vlan" some messge like that..and doesnt allow me to set a IP address to it...My cisco has the IOS Vers...

Hello, Please forgive my complete ignorance.I have a 2501 router, and it has the aux to ethernet adaptor.I want to hook it up to my computer which runs 2k adv serv.Do I hook the pc to the aux/eth adaptor, or directly to the console port.How do I...

There are so many different versions of IOS. How do I know which one to use? Do I just use the newest one?

A catalyst 6513 with Supervisor Engine II,6816 GBIC Interface Card,IOS c6sup22-dsv-mz.121-8a.E5, a sup-bootflash. The current regist value is 0x2, is it correct?

Hi Guys,My network is 10/100 and have devices with NIC 10/100 and others with NIC 10, someone told me that when you have some device with 10 MBps with others with 10/100 in the same network all must be configured to half duplex, that is right ?Thanks...

I have a 10Mb link coming in to my 720vxr router from my ISP. What good monitoring software can I use to my sure my ISP is giving me what we are paying for?

Hi there I am trying to do a tftp download from a Cat 4006 Switch, but have only ever done it on a 3500.What are the correct commands to do this...ThanksAlvan

Hi I need help I'm trying to set the SNMP information on a Cat 4006 Switch but unlike the a 3500 switch which seems pretty straight forward I'm getting confused of which commands allow you to put the cummunity string, contact and location information...

Hi guys,trying to bring up an ISDN interface at 7am and downing it at 7pm everyday. The router is a 2503. We dont want to use interesting traffic to bring up and down the interface (business reasons).Anyone got any ideas as to how this could be achi...