I have RV042 Router I want Activate Trend micro Protect Link Getway. I dont Have a key Even if i get Demo version it will be ok, First i will try then I can purchase the same,
My company has recently upgraded to IOS c2801-adventerprisek9-mz.124-24.T3.bin. All routers routers are configured with two ntp servers. Routers with the above IOS need a great amount of time (even up to a day or more if not triggered manaully - reap...
[New to the community, not sure where to start first, so I picked here!]I have an old 2610 router that has been mothballed for quite a while now, that I'd like to reuse for a different purpose. To do so, I'm going to need an additional module, which ...
I have a uBR7225vxr, with a uBR-E-16U card, which, is basically is as we received it from Cisco. It's never been used, nor even powered up as far as I'm aware, but it's been hanging around for 2 years now.However, we need to get it configured up to ...
I am at thhe early stages of looking at this, and am just interested in anyone else has seen similar that may save me a little work.We have a 3750 connected to 2600 routers. both ends are configured 100/F but the switches keep going to 100/H after a ...
I have been going through the config-register and I know the following to be true:0x210X = 9600 baud0x212X = 19200 baud0x312X = 57600 baud0xXXX0 = ROM0xXXX1 = Bootstrap0xXXX2 = NormalThe problem is the ignore value of 0x2142. My question is "Does any...
Does anyone know if the console speed of a Catalyst 3750 can be changed? The switch does not have a valid IOS image installed and the only prompt accessible is the Switch: recovery console prompt. Before using the xmodem I am hoping there is a way to...
Can all the upstream freq. be the same as long as different ports are used to recive them form the different nodes? And the load balanced ports have to have different freq.?
Hi,I'm trying to convert Cat OS to IOS, below are some info:Hardware information:Mod Slot Ports Module-Type Model Sub Status--- ---- ----- ------------------------- ------------------- --- --------2 2 2 1000BaseX Supervisor WS-X6K-S2U-MSFC2 yes ok16 ...
Hello,Today I have plugged in a new Cisco 2901 ISR G2 router into a Cisco 2950 switch.On router side, the interfaces were hard coded to 100/Full and on the switch side all set to Auto.On router, the commands SHOW IP INTERFACE G0/0 and G0/1shows speed...
Hi All, We've been upgrading to Internet Explorer 7 and we've realised that the current web server on our Cisco switches doesn't like this browser. Does anyone know if this is this fixed in latest version of the IOS? All I can get from CCO is the sup...
hi, i have a 2048kbps link to internet and i have this networks 148.235.79.16/29 and 148.235.79.24/29 configured in the cisco router, how can i do to configure that network 148.235.79.16 use only 512kbps of the link and network 148.235.79.24 use 1526...
Hi all,I'm trying to do the following but i need a little help with this.Scenario:I have 2 routers that are connected via a VPN tunnel and both have internet connection. On both routers I want to make sure that internet is working with PAT but when m...
Hello all,I want to know if i can configure the Ethernet over IP on cisco router. This configuration is possible on Mikrotik equipment.If yes, what is the commande line please?Thanks in advance.
