I need to do to swap out my N2K-C2248TP-E with N9K-C93180YC-FX3. All my searching has turned up nothing regarding a procedure to achieve this. Regards Fabian
Forum Posts
we want to do a renewal support of virtual cisco prime 3.4. but the serial number that appears on the UDI is not readable on the CCW-R. did we make a mistake in looking for the serial number to be renewed? or what do we need for the renewal of Virtu...
Hello, In my network connection tools, I can't find cable splitter but can find coaxial splitter. I would like to know if they are the same, if no, then kindly guide m
Hello, In my packet tracer, after connecting the coaxial cable splitter (coaxial2) to the TV using the TV cable, once I turn on the TV, there's a green arrow signal and when I turn it off, it shows a red arrow signal. According to Packet tracer, if...
I am trying to configure a NTP IP address to be configured as a systems peer. not sure what the command is for this or the steps to getting it to populate as a systems peer under my NTP peer associations list.
I would like to see terminal logging output during an SSH session the same I would see when I am consoled into the device. What I mean by terminal logging is output to the terminal screen when events happen (OSPF neighbors connect, a port is disconne...
We are planning to migrate the nexus switch 7004 to nexus 9300 switches . We have three vdc (one admin , one layer 2 core and one layer3 ) . I am doing ist time datacenter core migration . What all precaution we have to take ? what will be the ma...
Hi Guys,I am practising the subnetting topic and Need a assistance in Usable host part.Below is the scenario:-My requirement is for 510 hosts.IP address:-192.168.1.0/23My subnet mask is -255.255.254.0i/p range-192.168.1.1-192.168.1.255192.168.2.1-192...
Hello, I want to transfer new image onto the CISCO2911/K9.I'm using freeftpd the authentication with ftp server works then file is being transferred but the file size is not correct. It should be 107,904KB and not 463320 bytes.I've tried removing the...
Is additional memory required to use the Boost license on a ISR 4331? We are looking to add the Boost license to an ISR 4331. I heard that additional memory is required beyond the default 4 Gig that comes with the 4331. But I cannot find that state...
Good morning everyone.I needed your help to understand if it is possible to configure a HWIC interface... so that it has access to a vlan configured on the same router, but on a sub-interface of an L3 interface. I also attach a packet tracer file wit...
Hello friends. I have not been able to solve a computer’s internet problem for the last 2 days, that is, every time I try to connect the Internet to my computer, the DNS server not responding, an error is showing. I am currently using Cisco Linksys E...
Hi All,i would like some advice with regards to a special case. attaching a diagram where i have a new vpc pair and one of the nexus is having a L3 point to point with an upstream L3 switch (4900). Apparently this is not a supported topology and wond...
I have a network with two new SG350X Switches in a Stack as core switch and some 8 Port SG250-08HP Switches in areas where not enough sockets are available.When I connect the 8 Port Switch to the Uplink, the switches both react normally and realize t...
Hello!Maybe someone has a solution.I try to get 802.1X working. It is working so far. The computer authenticates against the IAS/Cisco ACS server without problems using EAP-TLS.The problem is that there is a delay of 10 seconds before the authenticat...
