Other Network Architecture Subjects

Hi, Can anyone help me in following issue:I have a Windows 2003 domain Controller/server and 20 LAN Domain computers/users. I want to just synchronize domain clients time with server time. Although Server itself is updating clients time after every 4...

I am in the process of cascading several 3560 switches together back to our 6500 core, and want the traffic to flow "up", rather than allowing spanning tree to choose the bottom switch to go "down" back to our core. I have modified both path cost and...

Dear All;I have Cisco 7609 router with 2 sup 720 installed in slot 5 & 6.On the same cisco 7609 router I have 2 WS-SVC-CMM-6E1 in slot 1 & 2.I put an IP Address in Cisco 7609 in gigabitethernet port 5/2 (media type rj-45) let say 10.0.0.1/8 and in th...

Hi All,I have got a 3560 SMI Switch.However whenever I configure Static Routes on switch and try finding the same by the command sh ip route static, I never see an entry.Is it that switch is having some issue or its normal behavior?Looking forward fr...

If I want to route through a cyrto map to my site, do i apply the map to an interface, then point the routes to the peer ip address, or do I point them through the serial, and use an access list that looks at the source then encrypts them through the...

Guys,Can I use this in my switched network design, (without using 802.1q tunneling as documentation always seems to mention this vlan in a vlan scenario???)I have native vlans and I want to act upon the 802.1p CoS field from end-to-end in my switche...

Hi,http://www.cisco.com/warp/customer/473/21.html#vtp_ts_cavstates that a vtp client with a higher revision number can bring down the rest of the network by replacing the vlans on the rest of the switchesHowever CCIE routing and switching Official ex...

Hi allwhat is the bandwidth of frame relay links, is it 2048mb, and can you apply this to ethernet, serial interfaces etc ?

Hi all,I'd like to monitor some devices using following commands..router(#)term le 0 sh led sh context sum sh diag sh cdp nei sh int sh env sh ver sh proc me sh proc cpu ...

HiI have 4 links which are bundled together in multilink. I receive lot of CRC errors in 2 links and hence i removed them from the bundle and gave them for testing. The circuit was clean and did not produce any errors for 24 hours. But as soon as i a...

Does anyone know about this error? I got this error from Cat 6509.Thanks

Hi,I want to setup a simple Looped configuration using 3 switches 2x 2980 and 1x 3560. Both the Routers are having HSRP configured and terminate on both the switches and connected to the Routers using VLAN -1.Also to make everything smooth I created ...

Dear all,I have a subnet 172.18.1.0/24 configured on vlan. I am trying to apply the below acl,ip access-list extended ota-acc1 permit ip 172.18.1.0 0.0.0.64 any2 permit ip 172.18.1.0 0.0.0.255 192.168.240.0 0.0.0.2553 permit ip 172.18.1.0 0.0.0.255 1...

Is it possible ?regardsNeo