This will hopefully be interesting enough to get some good input from you guys.I'm curious where (in the stack) the problem occurs when you have a bloadcast storm scenario. Is it more likely to be at the hardware (network interface) level, or at the ...
Say we have a Cat3850 48x1G and a Nexus 3k. 24x10G I have a connection between them and can verify that both are running 1G speed between links. Is there a Cisco tech/feature where i can increase the speed between links without upgrading the devices?...
Recently taking on the responsibility of a new position I noticed a static route in the routing table. When I try to remove it I get "%No matching route to delete". Talking with another employee he told me they added a default-network statement at...
Hi,I notice some network have dual home servers.They access the DC server via network card 2 and they aslo access by using network 1 as per below diagram Existing network portion. Some servers of some network used one network card or sometime NIC tea...
HelloI would Like to Know If CISCO support ONE to MANY VLAN MAPPING ( VLAN TRANSLATION)thank you for Support.
Hey guysI have one L3 Router from Cisco and two companies. Company two is joining our office in the next months. Company two should have some vlan networks and access to our Firewall and the Internet behind. Now to question: Is there a better way to...
So, I am getting this error on Prime and it says this:"Interface'switch name'/GigabitEthernet4/0/3:value of Interface Inbound Errors = 100%violated the set threshold: 25%. Additional:InPktErrors=100%, OutPktErrors=0% -Automonitoring - Link and Trunk ...
Hi There I have two Cisco SFP modules GLC-BX-U. One have part number 10-2094-02, other have number 10-2094-03. What is the difference between them? Best regards
Hello, Just want to clarify: in CCW when I configure either a 4351 and 4451 ISR voice gateway, I can use the 2x NIM slots for voice cards/modules and 1x NIM for UCS-E blade. If I want the ISR to support 2x additional voice cards/modules, can I just u...
Hi Techguys,I have Core switch with NTP Master and Layer 2 switch is client for NTP Time synchronization. Clock is synchronized but time in not correct on the client.CORE configuration:Interface loopback54 (172.16.10.254)ntp broadcast version 2ntp so...
Hello All. I have EHWIC-4G-LTE-G in Cisco 1921 and problem: #sho invNAME: "CISCO1921/K9", DESCR: "CISCO1921/K9 chassis, Hw Serial#: FGLxxxx, Hw Revision: 1.0"PID: CISCO1921/K9 , VID: V05 , SN: XXXXNAME: "4G WWAN EHWIC - Global Multimode LTE/DC-HSPA+/...
Hi,I am trying to make Android ACTS setup for WiFi testing. I tried with setup as below:Android DUT (debug) <=> Ubuntu Machine + Python + ACTS "tools /test/connectivity" <=> Cisco WLC2504 <=> Cisco AIR-CAP2602I-A-K9 As per the config json files, Acc...
Does it make sense to use 50/125 OM3 fiber with Cisco MGBSX1 Transceivers?
I have an EHWIC-4G-LTE-A I am using to connect to an LTE/HSPA provider (non ATT) and am able to receive an IP from the ISP, however I'm not able to ping out of the interface to the internet nor am I able to ping the interface IP. I'm about to check w...
