Hi allwhat is the difference between3750-s 3750-eonly Enahanced image if so can i upgrade 3750-s IOS to 3750-ei will perform all the task what 3750-e can give ??ram
Hi,I have one 3750 with the SMI version and need to duplicate a Multicast flow twice without any routing feature. Is the SMI version sufficient ?I have about 400 Mbps of incoming payload .I already created a trunk with .1Q encapsulation.Thx
HiAfter upgrading one of our Cisco 2620 Router with a wrong version of IOS, the Router has lost all its interfaces. i.e. It does not show any interface at all in the show config.What are the methods to retrieve the router back to its normal stage a...
IP Multicast Forwarding Information BaseEntry Flags: C - Directly Connected, S - Signal, IC - Internal Copy X - Inactive, D - Dormant, * - MFIB special entryInterface Flags: A - Accept, F - Forward, S - Signal IC - Internal Co...
We have a switch 'sits' between Quest router and our firewall untrust connection... VLAN1 management ip is a public ip, can we do acl or something to secure this switch?
Hi ...I'am looking into, how to provide Transparent LAN Services, between 4 site, that are interconneced on Layer2, I don´t want to implement MPLS, in my Layer2 core, the services I want to provide is transparant vlan's, Customer1 have connection to ...
Hi,I understand that the Cisco 3550 (EMI edition) does not yet support track ip command.Basically, I have this switch which is connected to a router. The default route is to go via this router. However, I want the default route to change if the WAN...
We recently upgraded a few 4006's with Sup II's in them .Also seeing the same problem on 2980's with this code. Now when you do a ping test from the switch the ping times are extremely long as an example300 packets transmitted, 300 packets recei...
En un ambiente donde se encuentran operando 2 equipos switch 4507, y a ellos directamente conectados equipos switch 2950 cual es lo mas recomendable utilizar VTP TRANSPARENTE o CLIENT ?
We use several 2950c switches and all ports 2-23 are protected with the command "switchport protected". Every now and when laptop users would connect to the port it would work fine and then it wouldn't for the next person that uses the same port. Reb...
I am having an issue where i can log into the switch via telnet or ssh but when i type "enable" i get an error that states "% Error in authentication". Has anyone seen this? It doesnt even give me a change to try to login when i type "enable" it just...
To my understanding, the designated port becomes the forwarding port, which means that its forwards frames. Root port has the lowest bridge ID and it also forwards frames...does this mean that the root port is the designated port? what is the differe...
Using 2 Cisco 3750's which are connected to each other, is it possible to have, for example the 192.168.50.0 (255.255.255.0)network existing on both routers. I realise that under normal conditions that this would not be possible, but am wondering wou...
