Other Security Subjects

I have a win2k server in a DMZ and I would like it to join my NT 4.0 domain on the inside network. I would like to know what ports/protocols need to be opened. The static mappings are in place and I setup the lmhost file on the win2k server. Any addi...

I've been consistantly getting 1000's of syslog messages (severity 3) like this:106011 Deny inbound (No xlate) udp src outside:x.x.x.26/1025 dst outside:y.y.y.245/137106011 Deny inbound (No xlate) udp src outside:x.x.x.26/1025 dst outside:y.y.y.163/1...

Hell-o all,Just setup and testing two pix515e firewalls. We want to use these boxes in a failover configuration. I understand the failover cable connection between the boxes. We also recieve two additional single port nics. Are these for a dmz se...

Does anyone have any experience running a dynamic routing protocol over a GRE tunnel whose peer is through the internet? My question is, if so, have you run into issues of route flapping do to the potential stability of the Internet? Would it just ...

I am having some difficulty configuring a VPN between two Cisco IOS routers. I can establish the VPN and packets are been encrytped, however my problem is when I apply an inbound ACL on the external interface, the VPN end point, the VPN can still est...

Hello allI have followed Cisco 's instructions for password recovery from the CCO website. http://www.cisco.com/warp/public/474/34.htmlThe problem I am having is that they appear to be incorrect. Item number 12 ... gives instructions to type"mount ...

Could anyone give me a link to a full resource of CISCO protocol entries in RADIUS A/V pairs.I know that shell: and ip: are such protocol entries but I would like to have a full description of all protocol entries.any help would be greatly appreciate...

When I open the pdm, it adds numerous number of "pdm location" statements to the running configuration. This is despite the fact that I've already added just the single required "http" and "pdm location" statements to the config. Is there anyway t...

Where can i find the docs for configuring tunnel between CISCO VPN 3000 concentrator and checkpoint FW NG

I have 2E1 (R2) on cisco route 3640.

My customer has a Pix 520 with 4 interface card attached. Is the version 6.21 compatible with PIX520 and all the accesory cause we planning to upgrade the flash file.Thanks in advance.

Hello, We have two cat 6509. The 6509 connect through trunk.Each 6509 has a idsm module in slot 6, the idsm communite with cspm. problem:1 command : show port 6/1 display the trunk's speed is 1000M .I want to know how many packet a idsm can proc...

Dear All,Does anyone know what are the upper limit of the following numbers when we do "show perfmon" ? For example if the "xlates" current is "100000/s" than the PIX has reach the upper limit of its performance, and that is the time to upgrade the h...