The problem's topology is :http://best.godcn.com/geniusccie/other/topology.gifProblem: Only one workstation can access US side 192.168.10.29 through a VPNtunnel, not support multiple workstations to connect to 192.168.10.29simultaneously.1.Firew...
Server is a Cisco VPN 3015, clients are using Cisco VPN Dialer version 3.5.1.I have a client that has a DSL connection using NAT sharing 1 external IP address. When one PC connects everything runs fine, when a second PC makes a coonection the first o...
Hi to all, I dont have ACS and any firewalls.Anywhere from the intranet can access all the commands in the router.I Configured the AAA using local database and created only 2 usernames.I want the other user shoult use only few commands in the user & ...
Can I use ACS2.6 to authenticates users on my LAN ? I know it works perfectly on Dial-Up but I'm having now additional users connected directly to the server but I'm not able to verify user IDs and passwords.Thanks
greetings,i have been given report that idle telnet session have been dropping out since i moved devices behind the PIX. Are there any issues i should be aware of in regards to PIX IOS v 6.1(1)Hardware PIX 515Is there a time out set for tcp sessions....
i am currently implementing a simple connection to isp. the isp assigns dynamic ip and i want to perform nat inside to 192.168... it is a peer to peer network. the router is a 1605r isdn with vers 11.1(5) ios. will i need to upgrade.many thanks
Can you tell me how diff log.YYYYMMDDHHMM and iplog.xx.xx.xx.xx.YYYYMM.....I set the signature action with "IP Log",so it result the iplog.xx.xx.xx.xx......right??so , If I don't set ALL signature action with IP Log,I will not see any iplog,right?pl...
Hello,Is it possible that I can access the PDM from outside interface of the PIX from two different LANS.Ie let say two different subnets.one 10.1.0.0/16 and 10.2.0.0/16.If yes how do I configure the PIX.Also when I install PDM on the PIX ,how do I c...
I just received the IDS Update Bulletin #31 stating S25 was released. I proceeded to download the update for the CSPM however it was not listed on http://www.cisco.com/cgi-bin/tablebuild.pl/cspm . I was able to download the update for the sensor ap...
I have a PIX 515 with three interfaces (inside,outside, and DMZ). We want to install a Proxy Server on the DMZ, so that all inside hosts will access the Proxy first instead of going to the Internet directly. The Proxy will be a Microsoft ISA applicat...
I liked to configure a pix from the beginning. Therefore, I have entered <write erase> and <reload>. Bevor the interactive dialog starts, the pix displays: Cannot select private key.What does this message mean? There is nothing but the default start...
Has anyone run into a problem where PDM hangs when grabing the config.It will not get past the section of VPNGROUP. It sits there forever. and never continue past this point.I have met all the requirments on my laptop and IEI am running PIX515E wit...
I am trying to tune event 3050 so that it will fire only once a minute maximum and then only if there have been 10 instances of this event from a particular source. Looking at the parameters in the tuning section, there are a few that seem to make se...
I want to authenticate outgoing tcp connections via the pix. Therefore, I have configured the aaa(-server) related commands.Everythnig is working fine. The command <show uauth> lists an absolute timeout (default: 5 minutes) and an idle timeout <0:00:...
