Other Security Subjects

We’re using a Cisco 2600 series router to give our customers remote support over ISDN.Our customers are using Cisco 801 ISDN routers.When we connect to a remote site, the 801 router calls us back.But our customers can also build up a connection to ou...

I have several win2K clients that are currently behind a PIX doing NAT, and they are accessing shared resources on NT servers that are on the outside. One thing we cannot get working properly is netlogon against a PDC/BDC that is outside the PIX. A u...

For example: If I wonted to permit the access to the FTP in the Host 10.13.0.5 (DMZ) from the private LAN (10.2.0.0) but not from the internet. Can I doit with the "conduit"? Thanks.

I use VPNClient3.0.1 to access PIX506 v6.0(1). I believe there are newer versions of these: what benefits would we gain by upgrading?If there are benefits, where do I obtain the upgrades?ThanksMichael

how to get radius software,anyone know that ,pls tell me as soon as possible.thanks a lot.

I have been running CSPM Version 2.3.3i with sensor version 3.0(3)S10 until yesterday when my NT server crashed during a database backup. I was able to restore the database from a previous backup and also restore my topology from a previous backup. I...

IOS can send an snmp trap in response to an snmp authentication failure (invalid community string), but can it also send this notification via a syslog message?How about syslog messages or traps in response to failed login attempts?thanks for any poi...

Does PIX support PPTP traffic with Dynamic NAT. Cisco routers supports this from IOS ver 12.2 onwards.

Hi,How do i specify port range for global inside or outside address?amdcent

I am trying to FTP the log files directly from the IDSM. I am using version 2.3.3i S11 of CSPM and 3.0(2)S10 on the IDSM. The instructions for configuring this are pretty cut and dry, but when I click on the "Generate audit event log files" option ...

Is it possible to configure separate inbound and outbound passwords in ACS 2.4 (TACACS+)?

Hello,our pix is configure the following way...name 10.50.1.18 pixbx_ext...ip address outside pixbx_ext 255.255.255.252...route outside 0.0.0.0 0.0.0.0 10.50.1.17 1Now our Network administrator gave us also the full class C 10.57.32.0 255.255.255.0. ...

I have two pix 515 firewalls. I'm ready to configure failover.I believe my best option would be stateful failover.I have a 100 mbps ethernet interface available on both firewalls to allow for the passing state data.Do I still need to make use of tha...

Has anyone ever tried to upgrade a PIX 520 with 5 interfaces to one with 6 interfaces. I have 1 pix 520 with 6 interfaces and one with 5. I would like to add another ethernet interface to make it 6. My VAR is telling me that they do not sell 2 port e...

I run a PIX520 V6.1(1).I have installed PIX FW syslog server PFSS on WinNT4.I get syslog records there, but I cannot see the hostname of the originating PIX in the syslog records. I only get messages with some strange <nnn> numbers at the beginning (...