We have branch offices using a VPN connection to our Home Office. Everything works fine except pings.I can telnet to outside interface on 1620 series Cisco series Firewall. But can not ping my clients on the LAN. If I then telnet to the inside inter...
I have two PCs (with private IP addresses) mapped to public IP addresses through a Cisco router doing one-one NAT. Is there any way I can send packets from one PC say A to another PC say B using B's public address? I can ping B's public address from ...
For some reason, our CSPM(2.3.3i) DB lost data for the last 5 days that was there the day before...still investigating. I restored the DB from the backup we did 3 days ago, reinstalled the S15 signature update, and uploaded the configs to sensors. ...
I have been placed in a position to start learning the security side of things and am beginning to dig into our CSPM system (host for 4210 and 4230 sensors.) I looked through the reports but cannot see any method of having the report create a tab (o...
I finished my CCNA certification 3 months ago.I was working on the network and i had to install a switchCatalyst 2900 series. OK i started doing some tests and then setting some password etc. Well I have this particular switch which i locked out. I p...
Is it possible to configure the ip auth-proxy to authenticate on a destination address. I noticed that a standard access-list is used, can you use extended access-list. Please give me an example if this is possible. Thanks in advance.
Following on from my previous conversation as suggested I am pasting the pix config for suggestions.ThanxsPIX Version 5.1(2)nameif ethernet0 outside security0nameif ethernet1 inside security100nameif ethernet2 dmz1 security10nameif ethernet3 pix/intf...
scenario :I'm trying to install two VPN 3030 in VRRP connected on 2924XL-EN switch. On the same switch, I have my router linked with WAN.I cannot ping my VRRP address of VPN'sIn ARP cache of my router, MAC address for this address is incomplete ?And ...
Hi..I am running sensor 2.2.0 and director 2.2.1. I have obtain nrUpdate-sol-sparc-2_2_1_8.bin from the vendor. But there's no readme with it. How do i execute the binary file on the sensor and where should it be placed. By the way, is the signature ...
I've been trying to find the answer and tried many different configs to no avail. Here is what I have and what I want to do. I have a 2514 and one static ip from my cable modem provider. I want to put the public ip on one eth interface and a privat...
I have a 4210 sensor that packetd is not initializing. It is one of 3 4210 sensors in my environment. I would like all possible options other than using the 2.5 software recovery.
Hey all - My database (using CSPM 3.03(S13) with Unix IDS host sensors at (S13) as well)is corrupted. It will let me view the database if I keep the selected period set after Jan 24th but if I try to view earlier events it generates "memory" errors....
Hi. I'm trying to use STATE.HTTP to detect the User-Agent header of all my inbound Web traffic and parse the value of it to detect crawlers, robots, etc. Any suggestions?
When I get this message, I am assuming there is a limit to how many IPs can be blocked in the deny ACL applied to the routers. Is this a hard limit, or can I change it? If so, where? Are there any potential hazards to raising this limit? I don't ...
