Other Security Subjects

I have a single pix 515 running between a linux firewall and the internal ip network. The pix provides nat/pat translation and firewall services to our inside network. The linux firewall provides initial firewall blocks and bandwidth shaping at the...

Hi all,i installed VMS 2.2 with IDS MC 1.2 on win 2000 server SP 4, but when i'm going to update signature/service pack VMS crash!! This is my environment:1) WIN 2000 server SP4 & explorer 6 SP12) Microsoft Java VM3) VMS 2.2 + update 14) IDS MC 1.2...

Not sure where to begin troubleshooting ,but the scenario is as follows , i`ve got two sites connected to each other through frame relay on point-to-point subinterfaces ,one site has Cisco 2620 and other site has 3745. I`ve got an ACL on the 2620 sub...

Hi,I have generated a report at security monitor 1.2.3 that is sent to me via e-mail. Works fine, but in the e-mail I just get a URL that links to the VMS server and the url is https://vms01:443/ids-monitor/GPS?p=s576.do&c=/ids-monitorAs vms01 is nor...

I used Nessus to scan our networks and have the following questions:1. I scanned the IP addresses of the border routers and DMZ. Is that sufficient? What other are needed to scanned?2. When I scanned one of the routers, the Nessus scanned through th...

Anyone know why in VMS the sensor Version does not update after a scheduled auto-update of the signatures?You can Query the sensor and it will update, but will not do it on it's own.

Is there a way to log who has been connected to a 3005 concentrator. Don't know if it matters, but the groups use NT authentication and I need to monitor/record usage at the user level.

I have configured WEBVPN on my VPN3015 running 4.1.5. I can connect and authenticate fine but when I open my mailbox it loads all the graphics and frames but it pops up a runtime error in Line 1018 and asked if I want to debug. I never get any of m...

I am trying to install a SSL certificate on a concentrator 3000 for webvpn connections. I have looked through a couple of notes attempted this but I cannot get it working. Were do I generate the key ? The only SSL certificates are the cisco ones u...

Hi,Can anyone reccommend a good CCNP simmulator ?

Can someone quantify this, I added a very large access-list (130 entries) to a tunnel a few days ago on an old pix and customer traffic was heavily impacted the pix setup: "Version 5.1(2), Finesse Bios V3.3, Hardware: SE440BX2, 128 MB RAM, CPU Pent...

Hi,Anyone could tell me what are the ports (udp and tcp) needed to be opened for MS w2k and nt file sharing?Thank you.

I have a Pix 515 that was just upgraded to the 6.3(3)FOS and now I have a problem. I have an Exchange server sitting on the internal interface that is NAT'd to an external IP address which we use for email. Prior to the upgrade our INTERNAL users (...

I'm running Netware. My NDS master replica is on my internal network. I am installing a GroupWise server on my dmz. I want it to be in the same tree. How do I allow the Netware/GroupWise server, on the lower security interface, to communicate with ...

Hello,I have installed CiscoWorks/VMS/IDS MC, for report generation purpose. I can generate reports from management center and security monitor.But my problem is, when I generate reports from MC or security monitor it’s not showing the required infor...