Routers - Small Business

Hello, I'm from Venezuela and now I have a Cisco RV082 and I have some problems with https:// encrypted pages that are used most of all banks by page, once logged on that page you immediately ejected it, I assume that logical two internet connections...

I'd like to set each individual LAN port with different address i.e. LAN 1 192.168.1.1 and LAN 2 10.1.1.1 instead of using the multiple subnet feature and having all ports replying for the addresses created. Is this possible?Thanks

Hi,The scenario is as follows:- Small Home-Office network based on a Cisco WRV210 VPN Router connected to another WRV210 in a remote location.- The WRV210 provides 2 WAP-protected SSIDs, one for the office network and one for visitors- Wireless chann...

Hello all,i have two locations connected with a Wifi link. On location A, i have internet and a network 192.168.1.0On location B, i have intenret and a network 10.20.10.0On location A, the antenna can be connected directly on the network therefore it...

Hi,I want to know if is possible to publish a port of an internal server to be accesible from internet but only from a specific IP.I know that in Setup menu exists Forwarding but it allows to publish ports to all internet no matter the source IP.Than...

Dear Friends,I have a RV082 VPN Router. But my internet connection is ADSL brodband. How can i connect and setup a VPN connection to other RV082Regards,Jinto Antony                  

HI, I'm new to forum and CiscoI run 2 RV042 V1 for home and office with Gateway to Gateway VPN connection with single WAN connection in use. Everything works like a charm!I was even able to create VPN connection with 2 WAN connection on one Router an...

Hi,I'm using SRP527W router at the moment and there are 10 PCs in the office.First of all, I'm not expert on network administration at all.Anyway, I set up remote access for particular PC and it works good.I made it like this.   Add "Port Forwarding ...

  I'm use this router as a main router as my WISP connections. ISP assigned static. RV042 is in Gateway Mode. I have a static from the ISP with DNS'sEverything is working. I request from some clients that want to connect DVR's and IP Camera's.DVR's a...

Regards,I have problems with the RV042 router. Currently I have two Internet service is the first DSL service and the other is through cable. The problem is because the router is not doing the redundancy process. For example if DSL service fails, the...

We have an ASA as a central hub in an IPSec VPN community, with four RVS4000 branch office routers connecting into it.Setting up the VPN tunnels worked fine, except after a while the tunnels seem to disconnect all by themselves, and they will not rec...

Hi there,I'm trying to setup a VPN tunnel between a Cisco RVS4000 on our side and a Cisco ASA5520, to connect a machine on our local network to a test server on the target side. We have all the settings setup correctly and the tunnel is up and runnin...

The VPN tunnel to one of my my branch offices sometimes shows status "connected" (on both sides) even if the tunnel is down (ping fails).It seems to happen directly after a WAN reconnect which occurs every 24h (forced by ISP). The problems starts occ...

Hi.I'm using 470  (and counting) RV042 v1 and v3 and RV042G for VPN gateway to gateway to HQ for more than 2 years. I have following issues with few units at a time, but repeat random on several:- VPN tunnel work several days, and then remain disconn...