Routers - Small Business

Using a RVS4000, newly installed.Can anyone advise me how to get detailed logs from the RVS4000 firewall and IPS modules?I've setup email to send the logs and do get messages, but they contain very little information.  When I look at the logs manuall...

Is it possible to assign public IP address as Router's local IP address (RVL200, RVS4000)?

Dear,We need you help of the network layout below.equipment-------------------------------------------RV082 x 4 pcsAt the network connectivity, each RV082 have one broadband connection and DHCP server enabled and the router ip within the same subnet ...

Hi all,I need some help to troubleshoot an issue with the VPN.The actual setup is :INTERNET <--> Sagem LIVEBOX PRO <--> Cisco RV120WSagem setup with port TCP and UDP forwarded to Cisco (range : 1-65535)I have obliged to use the Sagem because it provi...

Hi brothers,I have got Linksys RV082 in my home network to use it as load ballancer between 2 providers.Is it possible to make some customisation in scenarioses and logging system? As I understand the device is based on some Linux core and Linux infr...

When configuring a SR520 static IP address on WAN port, popup box directs user to delete and re-enable NAT. After disabling NAT no button exists to re-enable NAT. If CLI is used to fix issue, CCA states firewall is not supported. Issue started with C...

Hi,   Trying to configure RV120W to act as a VPN Gateway (Responder) for VPN client.  We tried Mac's OSX VPN Client using CiscoVPN IPSec type... no luck and not much logs. We also tried with Cisco VPN Client on WinXP where we got more details as logg...

Hi all,I searched this community and didn't find a solution. Is it possible to VPN with a Mac to the RV120W?Regards, Ralph

I have three sites using the RVS4000 as a router.  Each site has a VPN tunnel to the other two sites.  One site has a web server.On the local LAN for the server, I can access a particular website on the server (e.g. https://extra.domain.com).  Howeve...

After setting up rv120w using VPN wizard I get the error shown below in the router logs. Also below is the default settings after wizard finished. I have a question about local and WAN id. Are they suppose to be set as local.com & remote.com? When I ...

My router at work is „ RV082“ .  I have a  dyndns-Address and can make a  login to the router via internet (DSL): HTTPS://mydomain.dyndns.org..  I have configured a client-access (without group-tunnel-configuration),  I have the newest FW 2.0.. and t...

Setup the RV016 and want to use it as PPTP server.  I cannot get connection.  Log file shows Feb 23 18:06:32 2011   Connection Accepted   TCP AAA.BBB.CCC.DDD:49507->AAA.BBB.CCC.EEE:1723 on ixp2 but get an error message on client.  A Connection could ...

Why is there only 1 DNS entry for the LAN side of this device? I need to be able to add at least 2 different DNS entries (redundancy) to allow client PC's to access local and site to site VPN servers with a DHCP assigned address. This would allow me ...

Hi,I bought a RV220W for my UPC 120Mbps internet connection and to replace a ASA5505.But i'm not getting higher then 60Mbps. wile connecting laptop direclty to cisco cable modem, the full 120Mbps is reached.I'm only testing this with a utp connection...