cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
564
Views
5
Helpful
2
Replies

2851 doesn't allow E1 controller config

clark-computers
Level 1
Level 1

I have a new 2851 running IOS 12.4(22)YB1. It has a VIC3-2FXS/DID card in slot 0/0 and a VWIC2-1MFT-T1/E1 in slot 0/3. in the running config, I can see the config for the voice-ports, but nothing for the controller. When I run 'show controllers' I get the two GBit interfaces and the NME-CUE module in slot 1/0, but no T1/E1 card.

However, when I run 'show inventory' and 'show diag' I can see the entry for the controller.

Is there something that I'm missing here that will allow me to configure the E1 controller?

Thanks.

Stu

1 Accepted Solution

Accepted Solutions
2 Replies 2

paolo bevilacqua
Hall of Fame
Hall of Fame

card-type e1 0/3

Fantastic!

Thanks, mate...

Review Cisco Networking for a $25 gift card