Routing

I have a Cisco 3845 router having with monitoring tool reporting high processor utilization. From what I know, RAM specs should also reflect in show memory. However I am observing that RAM indicated at the show version 256MB is different from the one...

Hello,      I wanted to get some opinion on what device would be better suited to be deployed at the edge of a site between an ASR or Nexus 7700? Specifically this device will be connecting to about 650 remote sites primarily doing routing. From a pe...

Hi,  Myself Anand Singarayan, I have a 1841 Router in which we have connected 2 ISP. Both ISP's are up but simultaneously when both link is connected on Router one is reachable and other one is not reachable. When I am disconnecting one link the othe...

Pretty basic issue here (core problem of a larger issue)...  I have a port forward setup:   ip nat inside source static tcp 198.168.1.10 1111 [our public IP address] 1111 extendable   Works fine.  But I would like to NAT the source IP to be an intern...

Hi, looking for assistance on an issue.   Our Cisco ISR router has three active interfaces -- one inside interface (local LAN), one outside interface to Internet, and one outside interface that is point to point connection to a colocated site.   The ...

i bought a cisco 2911 via ebay markes as spares or repair so it was no real loss if it wasn't working. however this one has a fault which i'd like any feed back on please. i plug a power ppluck into the ac socket, the supply ok light lklights up gree...

I am trying to find a site to download an IOS for a Cisco 3750E v. 12.2(35), specifically c3750e-universalk9-mz.122-35.se5.bin.  Can someone tell me where I can find it?  I tried the "Software Downloads" tab on the Cisco site, but didn't find it. I a...

I have 2 sites [Site A and Site B] connected via EIRGP. Current all internet access is via Site A. Site A send a default static route to Site B. I would like to add internet access to Site B. What would be the best way to dynamically failover interne...

Hi Guys,   We have a scenario where we have 2 x Nexus 3548 Switches that are peered together and are working fine.   Recently we had the need to start running OSPF between them and the firewalls, but i am not qutie sure if i had it setup correctly. E...

Hi all, hope everyone is well !!I've got a WCCP related scenario and am looking for some inputs.I have WCCP configured on a Cisco 3945 router to redirect traffic destine for some remote sites to a Silver Peak appliance. From the application level tra...

Hi. I would like to know about case as the below I've example configure in the vlan interface Vlan70ip address 192.168.1.1 255.255.255.0ip wccp 2 redirect in   <<<<<<<<<<<<<<<<<< ip policy route-map rm-to-proxy   <<<<<<<<<<<<<<<<<<      ip wccp 2 red...

Good morning,   I'm currently in the process of replacing our old 3845 router with a 4451. The issue is the 3845 router has an internal switch module and is only using 1 Fast Ethernet interface for tunneling distance learning traffic back to our cent...