Routing

Hello, I am trying to implement an AS Path filter for repeated AS Numbers without typing a long list. For example, in the below statement, I have to define the AS Number 65022 6 times using standard BGP regular expresison. ip as-path access-list 1 pe...

Hello, Im faced with a scenario that im not familiar with. We'll be installing MS expressroute over the near future and wanted to ask a question regarding learned routes from Microsoft. Microsoft have a number of public ip ranges that they advertise...

???

how can i change-adjustment the SNR  to cisco 887VA thnks Router#sh controllers vdsl 0Controller VDSL 0 is UP Daemon Status: Up XTU-R (DS) XTU-C (US)Chip Vendor ID: 'BDCM' 'GSPN'Chip Vendor Specific: 0x0000 0x0010Chip Vendor Country: 0xB500 0xFFB5Mod...

Hi guys! What's your advise? (except "get your CCNP") We are running web site on VM with public IP address. Company planning to move to other location and get service from 2 different ISP. To provide failure tolerance I plan to organize BGP with priv...

Hi Team, I have a Cisco Switch 3750 in production but i need to add a second switch as stuck switch can I do it while is in production or Do I need to shut down the switch. Also do i need to do any configuration after been install thank you team.

Hi, I have a HWIC-3G-HSPA setup as a SLA failover link in my 1941. All works fine and if the primary WAN interface goes down the 3G link comes up and all is good. But the cellular link times out and shuts down after about two days. I've set the dial...

I have a switch stack.Switch Ports   Model                      SW Version             SW Image                                      ------ ----- -----              ----------                     ----------               *    1   52      WS-C3750G-48...

Hello guys,When authentication is configured between two bgp peers at which bgp state router checks for password prior to neighborship between the peers?As per few documents authentication information is carried in open message, but tcp connection ta...

why is it my show IP bgp command does no responsd, what could be the problem?

Hello, is it possible to use the SFP-Port as LAN-Port? Thank you

I would like to configure OSPF and EIGRP redistribution on routers R0 and R1 via tunnel gre, like in the scheme. I will be greatful for help in configuration. Below is actual  R0 and R2 configuration  R0 interface Loopback0ip address 10.0.0.1 2...