Routing

I have several routers in a DMVPN with each other running OSPF across it.  I want some spokes to prefer routes from other specific spokes.  For example, suppose I have four offices: two in the US and two in Asia.  One office in the US has an Internet...

Hello, all. Are anybody know, how many RAM has C891F by default? Here I have found, that it has 1Gb fixed and not extendable RAM by default http://www.cisco.com/c/en/us/td/docs/routers/access/800/hardware/installation/guide/800HIG.pdf but here is ...

Good Morning, I just need to verify if my configuration for my internet router is correct for the port that connects back to our ISP.  Do I need to configure the vlan part on the subinterface anywhere else on my network or that is on the isp's side?...

I have a remote WAN site who has a P2P EIGRP and a 10Mb MPLS connection. Datacenter 1 is announcing 0.0.0.0/0 via BGP via MPLS to remote-site-ADatacenter 1 is also announcing 0.0.0.0/0 via EIGRP via P2P to remote-site-A Datacenter 2 is announcing 0....

Hello. We have a ftp server hosted as FTP Internal/External with the NAT and i have setup rules to allow traffic on ports 11000-13000,989-990,21,22 Internally all ftp protocols work but externally FTP S does not work and i have tried to figure out w...

So, I have a new 2921 connecting to a 100Mbps service (Internode NTU). If I bypass the router and connect a laptop directly to the NTU I get blistering 95Mbps ...  But through the router, with very simple config I cannot get pages to load, they time...

Hi, I would like to have your suggestions concerning Cisco routers that support STM1 Cards. I am looking for a router reference (product or part number) that supports 2 STM1 cards maximum, at least 4 GigaBitEthernet Ports and must support security fe...

I have two locations (Location A & Location B). I have data MPLS lease-line to connect this two location with two Cyberoam . I want to configure Same subnet IP address on LAN of both locations.so I need to specify same subnet IP on both sides.Please ...

I've come onto problem switching on BFD on ASR1k. after applying configuration on router bgp:  neighbor y.y.y.y fall-over bfd single-hop show bfd neighbors vrf 1001 details show nothing ASR1K1#sh bfd neighbors vrf 1001 details ASR1K1# Please see bel...

Hello. I'm planning a Network re-design. There will be a dual-homed internet connection(same carrier), terminating to ISR 4431s. A pair of ASA 55xxs will sit behind the routers. Palo Altos will reside the next layer in. - Where is the ideal locatio...

Hello , I have a branch office with Cisco 1941 router. As the branch office is in remote location there is no feasibility of MPLS. We have taken broadband internet connection in branch office. To start the internet connection i need to configure PPP...

A partner will bring an MPLS circuit to connect our sites. One of the requirements is to tag the packets since we will be having mixed voice and data on this MPLS circuit. They said they will enable COS on this circuit so as to prioritize voice over ...

Hi Guys, Can you take a look at this scenario and provide some feedback. We have this following type of QoS policy applied to the Cisco887 for use with VDSL. policy-map UT class UT  set dscp ef  priority 3000 class class-default  bandwidth percent ...