Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

Hi, Not sure if I'm on the correct path but I've been using other firewalls and this is the first time I've used Cisco ASA. This is my setup: Gi0/2 is our second ISP as backup I added a route using a test pc with a static IP, added that machine as de...

TECH-JEFF by Level 1
  • 1292 Views
  • 10 replies
  • 0 Helpful votes

Hi,  My CCNP expires in 01/02/2016, in the same date I did the exam 642-883 but I failed. I'd like to know if I till have a time for recertify my CCNP or I'll have to do again. Regards

Hi Experts ………….……[Source]                            | (rp)—2——1—(r2)  |  2                    |1  |                        |  |                        |  |                        |  | 1                     |2 (r3)—2——1—(r4)  | [Destination] if ...

pdiazq001 by Level 1
  • 389 Views
  • 3 replies
  • 0 Helpful votes

I was wondering if anyone knew if you had two next hops in a route-map, in two different subnets and they were equal cost if they will do load balancing or are is it going to just use the first "next-hop" address? (See sample configuration below) I w...

Hi all, We have two DMVPN hubs configure, one is an ASR 1002 and the other is a 3945.  EIGRP is configured to use the ASR as the preferred path. We have discovered that the spokes are seeing significantly lower upload speeds.  One site has a 40 down/...

Ben.Levin by Level 1
  • 414 Views
  • 2 replies
  • 0 Helpful votes

Hi all I have a DVR inside my company its IP address is 192.168.0.50 and port number is 2000 I want outside Internet users to access DVR, How is it possible? Please have a look at the running configuration. DVR is working inside the company but not a...

Good Afternoon, I have a Pix 501.  Am trying to change the outside route and keep getting an error.  Could someone please help.  As far as I can tell my syntax is correct but here's what happens PIX-501(config) # route outside 0.0.0.0 0.0.0.0 50.10...

I have a customer that wants to add a couple of small 4 port switches into their existing network to expand a couple of offices temporarily.  In their case, they have a pair of linked 2960X PoE switches that they would like to attach to. A test by o...