Hi,I need to deploy a setup with more than 1000 new Catalyst 8300 in a closed network. So I understand that for licensing I will go with the SLR option. Is there an option to generate/use the same activation file for all devices or do I need to use /...
Forum Posts
Resolved! LLDP run : the command NCS540 cisco
we have NCS540 cisco we wan enable the command LLDP RUN but don't work RP/0/RP0/CPU0:NCS540-RAS-JBEL#conf terminalThu Feb 22 12:46:44.923 UTCRP/0/RP0/CPU0:NCS540-RAS-JBEL(config)#lldp ?extended-show-width Configure Extended Show LLDP Neighbor Wi...
When we attempt to configure new ipv4 unicast BGP neighbors, the box informs us that it can't commit the configuration. When we issue the "show configuration failed" command, we get the following error message...'BGP' detected the 'warning' condition...
Hello guys. I have more experience in switching than in routing, so, I have some doubts regarding BGP manipulation.In the image attached, there is a diagram for any reference.What I basically want to know, is if there is a way to force that all Inter...
HELLO EVERY ONE WHAT IS THE MAIN FUNCTION OF THE NATIVE VLAN IN L2 AND L3 ?
Hello Currently running BGP EVPN VXLAN in one site, and planning to extend the fabric to another site. Can the spine switches at a site function as border gateways as well connected to a L3 routing network? Or do I need to purchase dedicated hardware...
Hello, We have 2 routers (Cisco 4331). They are programmed exactly the same. The bootflash available space is different from one another. We have verified the bootflash has the exact same files. Can someone explain why they are different . Thanks! ...
A) ip route 10.0.0.0 255.0.0.0 172.16.40.1B) ip route 10.0.0.0 255.0.0.0 serial0/0/0AM I RIGHT?
I'm configuring OSPF authentication in a lab on Packet Tracer. I have two PCs, two Catalyst 2960 switches, and three 4331 routers. I have configured PC-A and R1 and I tried pinging them, but I noticed something while I was pinging them.Here is my set...
Hello Dear Community, I hope you are doing well!I have a very weird situation which I couldn't explain it. As you know , if you want to redistribute routes into different protocol , it has to be in routing table from the particular protocol which you...
Hello all,I need help troubleshooting a multicast config, I am new to this network and I don't know much about multicast routing. I was told that multicast worked before VLANs were introduced. IP multicast is enabled on the core switch (cisco C9500-2...
Hello, I am looking for a way to do offline core dump analysis. Is this possible through a Cisco program or third party software?-Taylor
Resolved! SG350x to ASR for Internet
I have a SG350x-48P that I have turned L3 on. I have 4 VLANS that all have 172.16.15.0/26 and DHCP Pools for each. They all hand out IP addresses on their respective interface that have the vlan membership. I have one connection to and ASR1001 and...
I am trying to search for this stencil since hours and couldn't find one in the Cisco stencils library. Could you please help me with a link to this stencil. Thanks
This happens when upgrading firmware on IR 1101 Routers. What does this mean also a -71 error
