Routing

OK Experts,I have made this issue very simple for you guys to help me out.I  have two routers R22 and R23. I have configured the back up interface  on R22 to be interface fas 0/1. Everything appears to be working fine. I  issue the command show backu...

I observed two cisco 3945 routers lose IOS during password recovery. Router was rebooted, break sequence ctrl-break, then boot(instead of reset) issued. The router booted to its existing configuration or password recovery failed and router was power ...

Hi!Could someone confirm if SFP-H10GB-ACU7M and the new SFP-10G-AOC7M cables are compatible with C3KX-NM-10G module for 3750-X switches?Transceiver compatibility matrix http://www.cisco.com/en/US/partner/docs/interfaces_modules/transceiver_modules/co...

I need some help in plain English please.  The router stopped working and maybe just needs a reset.  I tried reading http://www.cisco.com/c/en/us/support/docs/ios-nx-os-software/ios-software-releases-123-mainline/46509-factory-default.html, but I don...

I have an already existing 6509 that is going to provide the entire MPLS routing table via route reflector to a new 6509.  Here are the relevant configs: EXISTING 6509 (Router A) interface Loopback0 ip address 10.255.2.2 255.255.255.255end router bgp...

Good morning all, I am trying to set up port forwarding for a Webserver we have hosted here on ip: 192.168.0.250 - I have set up access lists, and port forwarding configurations and I can not seem to access the server from outside the network. . I've...

I have a router (Cisco 3845 with 1GB of memory and running IOS 12.4.24-T7 Advanced IP Services) on which i am trying to implement a bgp session with my ISP. My router has the three following interfacesint g0/0 -> 26.30.80.92 (ISP side)int g0/1 -> 94....

Hello, This is for home use...I have Time Warner Cable at my house with a Dynamic IP Public Address. I have to implement VRRP into my network so I can have redundant routers incase one fails. I'm not completely sure as how this would work because I d...

 Basic setup and I must be missing something. Host---------------ETHERNET--------------------[1941]------------PPOE------------------------AT&T10.1.0.2/16                                     10.1.0.1/16      70.237.52.230/32                    151.16...

hello, everyone,I'm trying to do some redistribution of bgp into eigrp in gns3.This works fine, redistributing bgp into eigrp, I can see all my routes.router eigrp 1 network 10.2.2.0 0.0.0.255 redistribute bgp 65501 metric 100 1 255 1 1500 When I add...

Hi everyone,Has anyone experienced issues regarding multicast traffic for a Tomcat cluster not being seen as a source?Currently have an any source multicast (ASM) design with hosts running IGMPv2, using PIM-SM with an RP configured. The servers in th...