Routing

I used this configure:ip multicast-routingip pim rp-address 192.168.10.1interface FastEthernet0/0 description link to Patong ip address 172.20.246.46 255.255.255.252 ip pim sparse-mode load-interval 30 duplex auto speed auto!interface FastEthernet0/...

I suspect that fragmentation is causing some intranet sites not to open and I am wondering when or which one to use the IP mtu or IP tcp mss adjust. Or do I use both.Sent from Cisco Technical Support iPad App

You have two links between R1 and R2. One link connects over frame relay via OSPF Area 0. The other link is a dedicated PPP link that rides over area 45. The PPP link will primarily be the backup of the Frame Relay circuit between R1 and R2. How woul...

HI ,OID 1.3.6.1.4.1.9.9.187.1.2.4.1.6 Fetch advertised  Prefixes Total (Which included accepted  and denied routes) and not the Prefixes Current. Can any one know which OID need to used for advertised Prefixes Current only.thank-you

I'm looking for a Router that can be used on School Campus that could handle 200 Users and 5 Access Points and able to do web filtering, VPN Site to Site and VPN Client. I have tried the RV120W but it keep drop connection.  Any Recommendations?

Is there a password recovery procedure for the Cisco WS-SVC-AGM-1-K9 Anomaly Guard Module?We inherited one of these modules and want to get it up and runningin our lab but the root MP, root AP, tac-cli and admin password are unknown to us.The default...

Greetings,I have a scenario in which a user has a gaming console and tends to open a lot of ports or ends up disabling the firewall entirely to play online. I looked into DMZ solutions but I don't see a howto that really fits my needs (dhcp addressed...

Hi,I am trying to exclude one specefic IP while doing route summarization for a /16 block. One way I know is to exclude a smaller subnet containing that specefic IP from the summarization but would like to know if there's any other way to attain this...

HiI'm setting up a VDSL/ADSL2+ DSLAM in test lab. I'm using a Cisco877 to test out the intial config. The 877 can connect and sync however it cant ping any devices on the DLSAM network .The CISCO877 is configured to use NAT and i think NAT is the iss...

Sir,Is there any command to find chassis serial no. for Cisco 7206VXR router ?regds,aman

Hi,    Although i teach CCNA and CCNP and i still dont understand the concept of HDLC...i know that Ethernet uses MAC addresses at layer 2, Frame Relay uses DLCI numbers at layer 2 ok great....Then what does HDLC use????Dosent HDLC has a layer 2 addr...

Hi,I have an Public IP pool 1.1.1.1/29. With a Firewall & a cisco 1900 router.          I need to establish a setup as :(public IP) Firewall -> (public IP) Router (Private IP) -> Switch (unmanaged) -> End users.My concern is to use INTERNET from Fire...